Skip to Content

Proposed Rule

Small Business Size Standards; Waiver of the Nonmanufacturer Rule

Document Details

Information about this document as published in the Federal Register.

Document Statistics
Document page views are updated periodically throughout the day and are cumulative counts for this document including its time on Public Inspection. Counts are subject to sampling, reprocessing and revision (up or down) throughout the day.
Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


U.S. Small Business Administration.


Proposed rule; notice of intent to waive the Nonmanufacturer Rule for General Aviation Turboprop Aircraft.


The U.S. Small Business Administration (SBA) is considering granting a waiver of the Nonmanufacturer Rule for General Aviation Turboprop Aircraft manufacturing. The basis for waivers is that no small business manufacturers are supplying these classes of products to the Federal government. The effect of a waiver would be to allow otherwise qualified regular dealers to supply the products of any domestic manufacturer on a Federal contract set aside for small businesses or awarded through the SBA 8(a) Program. The purpose of this notice is to solicit comments and potential source information from interested parties.


Comments and sources must be submitted on or before February 20, 2004.


Address comments to: Edith Butler, Program Analyst, U.S. Small Business Administration, 409 3rd Street, SW., Washington DC, 20416, Tel: (202) 619-0422.

Start Further Info


Edith Butler, Program Analyst, (202) 619-0422, FAX (202) 205-7280.

End Further Info End Preamble Start Supplemental Information


Pub. L. 100-656, enacted on November 15, 1988, incorporated into the Small Business Act the previously existing regulation that recipients of Federal contracts set aside for small businesses or SBA 8(a) Program procurement must provide the product of a small business manufacturer or processor, if the recipient is other than the actual manufacturer or processor. This requirement is commonly referred to as the Nonmanufacturer Rule. The SBA regulations imposing this requirement are found at 13 CFR 121.406(b). Section 303(h) of the law provides for waiver of this requirement by SBA for any “class of products” for which there are no small business manufacturers or processors in the Federal market.

To be considered available to participate in the Federal market on these classes of products, a small business manufacturer must have submitted a proposal for a contract solicitation or received a contract from the Federal government within the last 24 months. The SBA defines “class of products” based on six digit coding systems.

The first coding system is the Office of Management and Budget North American Industry Classification System (NAICS). The second is the Product and Service Code established by the Federal Procurement Data System.

The Small Business Administration is currently processing a request to waive the Nonmanufacturer Rule for General Aviation Turboprop Aircraft, North American Industry Classification System (NAICS) 441229. The public is invited to comment or provide source information to SBA on the proposed waiver of the nonmanufacturer rule for this NAICS code.

Start Signature

Barry S. Meltz,

Acting Associate Administrator for Government Contracting.

End Signature End Supplemental Information

[FR Doc. 04-2239 Filed 2-3-04; 8:45 am]