Skip to Content

Notice

Request for Comments Concerning Proposed Extension of Approval of a Collection of Information-Safety Standard for Walk-Behind Power Lawn Mowers

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Consumer Product Safety Commission.

ACTION:

Notice.

SUMMARY:

As required by the Paperwork Reduction Act (44 U.S.C. Chapter 35), the Consumer Product Safety Commission requests comments on a proposed request for an extension of approval of a collection of information from manufacturers and importers of walk-behind power lawn mowers. This collection of information consists of testing and recordkeeping requirements in certification regulations implementing the Safety Standard for Walk-Behind Power Lawn Mowers (16 CFR part 1205). The Commission will consider all comments received in response to this notice before requesting an extension of approval of this collection of information from the Office of Management and Budget.

DATES:

The Office of the Secretary must receive written comments not later than May 30, 2006.

ADDRESSES:

Written comments should be captioned “Walk-Behind Power Lawn Mowers” and sent by e-mail to cpsc-os@cpsc.gov. Written comments may also be sent to the Office of the Secretary by facsimile at (301) 504-0127, or by mail to the Office of the Secretary, Consumer Product Safety Commission, Room 502, 4330 East-West Highway, Bethesda, 20814.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

For information about the proposed extension of approval of the collection of information, or to obtain a copy of 16 CFR part 1205, call or write Linda L. Glatz, Office of Planning and Evaluation, Consumer Product Safety Commission, Washington DC 20207; telephone (301) 504-7671.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

In 1979, the Commission issued the Safety Standard for Walk-Behind Power Lawn Mowers (16 CFR part 1205) under provisions of the Consumer Product Safety Act (CPSA) (15 U.S.C. 2051 et seq.) to eliminate or reduce risks of amputations, avulsions, lacerations, and other serious injuries which have resulted from the accidental contact of some part of an operator's body with the rotating blade of a power lawn mower. The standard contains performance and labeling requirements for walk-behind power lawn mowers to address risks of blade-contact injuries.

A. Certification Requirements

Section 14(a) of the CPSA (15 U.S.C. 2063(a)) requires manufacturers, importers, and private labelers of a consumer product subject to a consumer product safety standard to issue a certificate stating that the product complies with all applicable consumer product safety standards. Section 14(a) of the CPSA also requires that the certificate of compliance must be based on a test of each product or upon a reasonable testing program.

Section 14(b) of the CPSA authorizes the Commission to issue regulations to prescribe a reasonable testing program to support certificates of compliance with a consumer product safety standard. Section 16(b) of the CPSA (15 U.S.C 2065(b)) authorizes the Commission to issue rules to require that firms “establish and maintain” records to permit the Commission to determine compliance with rules issued under the authority of the CPSA.

The Commission has issued regulations prescribing requirements for a reasonable testing program to support certificates of compliance with the standard for walk-behind power mowers. These regulations also require manufacturers, importers, and private labelers of walk-behind power mowers to establish and maintain records to demonstrate compliance with the requirements for testing to support certification of compliance. 16 CFR part 1205, subpart B.

The Commission uses the information compiled and maintained by manufacturers and importers of walk-behind power mowers to protect consumers from risks of injuries associated with walk-behind power lawn mowers. More specifically, the Commission uses this information to determine whether the mowers produced and imported comply with the applicable standard. The Commission also uses this information to obtain corrective actions if walk-behind power mowers fail to comply with the standard in a manner which creates a substantial risk of injury to the public.

The Office of Management and Budget (OMB) approved the collection of information requirements for walk-behind mowers under control number 3041-0091. OMB's most recent extension of approval will expire on June 30, 2006. The Commission proposes to request an extension of approval without change for these collection of information requirements.

B. Estimated Burden

The Commission staff estimates that about 20 firms are subject to the testing and recordkeeping requirements of the certification regulations. The Commission staff estimates further that the annual testing and recordkeeping burden imposed by the regulations on each of these firms on average is approximately 390 hours. Thus, the total annual burden imposed by the certification regulations on all manufacturers and importers of walk-behind power mowers is about 7,800 hours.

The Commission staff estimates that the hourly wage for the time required to perform the required testing and to maintain the required records is about $42.84 (Bureau of Labor Statistics, June 2005), and that the annual total cost to the industry is approximately $334,000.

C. Request for Comments

The Commission solicits written comments from all interested persons about the proposed collection of information. The Commission specifically solicits information relevant to the following topics:

—Whether the collection of information described above is necessary for the proper performance of the Commission's functions, including whether the information would have practical utility; Start Printed Page 15389

—Whether the estimated burden of the proposed collection of information is accurate;

—Whether the quality, utility, and clarity of the information to be collected could be enhanced; and

—Whether the burden imposed by the collection of information could be minimized by use of automated, electronic or other technological collection techniques, or other forms of information technology.

Start Signature

Dated: March 22, 2006.

Todd A. Stevenson,

Secretary, Consumer Product Safety Commission.

End Signature End Supplemental Information

[FR Doc. E6-4475 Filed 3-27-06; 8:45 am]

BILLING CODE 6355-01-P