Federal Aviation Administration, DOT.
The Federal Aviation Administration (FAA) announces its determination that the noise exposure maps for Burlington International Airport, as submitted by the City of Burlington under the provisions of Title I of the Aviation Safety and Noise Abatement Act of 1979 (Pub. L. 96-193) and 14 CFR part 150, are in compliance with applicable requirements.
Effective Date: The effective date of the FAA's determination on the noise exposure maps is November 6, 2006.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Richard Doucette, Federal Aviation Administration, New England Region Airports Division, 12 New England Executive Park, Burlington, Massachusetts 01803.End Further Info End Preamble Start Supplemental Information
This notice announces that the FAA funds that the noise exposure maps submitted for Burlington International Airport are in compliance with applicable requirements of Part 150, effective November 6, 2006.
Under Section 103 of Title I of the Aviation Safety and Noise Abatement Act of 1979 (hereinafter referred to as “the Act”), an airport operator may submit to the FAA noise exposure maps that meet applicable regulations and that depict non-compatible land uses as of the date of submission of such maps, a description of projected aircraft operations, and the ways in which such operations will affect such maps. The Act requires such maps to be developed in consultation with interested and affected parties in the local community, government agencies, and persons using the airport.
An airport operator who has submitted such noise exposure maps that are found by FAA to be in compliance with the requirements of Federal Aviation Regulation (FAR) Part 150, promulgated pursuant to Title I of the Act, may submit a noise compatibility program for FAA approval that sets forth the measures the operator has taken, or proposes, for the introduction of additional non-compatible uses.
The FAA has completed its review of the noise exposure map and related descriptions submitted by the City of Burlington. The specific maps under consideration were “Figure 1. 2006 Existing Condition Noise Exposure Map” and “Figure 2. 2011 Forecast Condition Noise Exposure Map” in the submission. The FAA has determined that these maps for Burlington International Airport are in compliance with applicable requirements. This determination is effective on November 6, 2006.
FAA's determination on an airport operator's noise exposure maps is limited to a finding that the maps were developed in accordance with the procedures contained in Appendix A of FAR Part 150. Such determination does not constitute approval of the applicant's data, information or plans, or a commitment to approve a noise compatibility program or to fund the implementation of that program.
If questions arise concerning the precise relationship of specific properties to noise exposure contours depicted on a noise exposure map submitted under Section 103 of the Act, it should be noted that the FAA is not involved in any way in determining the relative locations of specific properties with regard to the depicted noise contours, or in interpreting the noise exposure maps to resolve questions concerning, for example, which properties should be covered by the provisions of Section 107 of the Act. These functions are inseparable from the ultimate land use control and planning responsibilities of local government. These local responsibilities are not changed in any way under Part 150 or through FAA's review of a noise exposure map. Therefore, the responsibility for the detailed overlaying of noise exposure contours onto the map depicting properties on the surface rests exclusively with the airport operator that submitted the map or with those public agencies and planning agencies with which consultation is required under Section 103 of the Act. The FAA has relied on the certification by the airport operator, under Section 150.21 of FAR Part 150, that the statutorily required consultation has been accomplished.
Copies of the noise exposure maps are available for examination at the following locations: Engineering Office, Room 295 Terminal Building, Burlington International Airport, 1200 Airport Drive, South Burlington VT, Federal Aviation Administration, New England Region, Airports Division, 12 New England Executive Park, Burlington, Massachusetts 01803.
Questions may be directed to the individual named above under the heading: FOR FURTHER INFORMATION CONTACT.Start Signature
Issued in Burlington, Massachusetts on November 6, 2006.
Manager, Airports Division.
[FR Doc. 06-9249 Filed 11-16-06; 8:45 am]
BILLING CODE 4910-13-M