Federal Aviation Administration (FAA), Department of Transportation (DOT).
We are adopting a new airworthiness directive (AD) for certain Cirrus Design Corporation (CDC) Models SR20 and SR22 airplanes. This AD requires you to replace the pick-up collar support and nylon screws, of the Cirrus Airplane Parachute System (CAPS), with a new design pick-up collar support and custom tension screws. This AD results from a CDC report of an in-flight CAPS activation where the parachute failed to successfully deploy. We are issuing this AD to correct pick-up collar support fasteners of the CAPS, which could result in the premature separation of the collar. This condition, if not corrected, could result in the parachute failing to successfully deploy (CAPS failure).
This AD becomes effective on August 16, 2007.
On August 16, 2007, the Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD.
For service information identified in this AD, contact Cirrus Design Corporation, 4515 Taylor Circle, Duluth, Minnesota 55811; telephone: (218) 727-2737; Internet address: http://www.cirrusdesign.com.
To view the AD docket, go to U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590, or on the Internet at http://dms.dot.gov. The docket number is FAA-2007-27976; Directorate Identifier 2007-CE-042-AD.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Wess Rouse, Aerospace Engineer, 2300 East Devon Avenue, Room 107, Des Plaines, Illinois 60018; telephone: (847) 294-8113; fax: (847) 297-7834.End Further Info End Preamble Start Supplemental Information
On May 11, 2007, we issued a proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to certain CDC Models SR20 and SR22 airplanes. This proposal was published in the Federal Register as a notice of proposed rulemaking (NPRM) on May 17, 2007 (72 FR 27766). The NPRM proposed to require you to replace the pick-up collar support and nylon screws, of the CAPS, with a new design pick-up collar support and custom tension screws.
We provided the public the opportunity to participate in developing this AD. We received no comments on the proposal or on the determination of the cost to the public.
We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial corrections. We have determined that these minor corrections:
- Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and
- Do not add any additional burden upon the public than was already proposed in the NPRM.
Costs of Compliance
We estimate that this AD affects 2,677 airplanes in the U.S. registry.
We estimate the following costs to do the replacement of the pick-up collar support of the CAPS:
|Labor cost||Parts cost||Total cost per airplane||Total cost on U.S. operators|
|2 work-hours × $80 per hour = $160||$17||$177||$473,829|
CDC will provide warranty credit to the extent noted in Cirrus Alert Service Bulletin No. SB A2X-95-10 R2, Issued April 2, 2007, Revised: April 24, 2007.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106 describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this AD.
We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a summary of the costs to comply with this AD (and other information as included in the Regulatory Evaluation) and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES. Include “Docket No. FAA-2007-27976; Directorate Identifier 2007-CE-042-AD” in your request.Start List of Subjects
List of Subjects in 14 CFR Part 39End List of Subjects
Adoption of the AmendmentStart Amendment Part
Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (End Amendment Part Start Part Start Printed Page 38000
PART 39—AIRWORTHINESS DIRECTIVESEnd Part Start Amendment Part
1. The authority citation for part 39 continues to read as follows:End Amendment Part
2. FAA amends § 39.13 by adding the following new AD:End Amendment Part
2007-14-03 Cirrus Design Corporation: Amendment 39-15125; Docket No. FAA-2007-27976; Directorate Identifier 2007-CE-042-AD.
(a) This AD becomes effective on August 16, 2007.
(c) This AD applies to Model SR20 airplanes, serial numbers (SN) 1005 through 1798, and Model SR22 airplanes, SN 0002 through 2437, that:
(1) Are certificated in any category; and
(2) have not incorporated the actions in their entirety of Cirrus Alert Service Bulletin No. SB A2X-95-10 R1, Issued April 2, 2007, Revised: April 10, 2007.
(d) This AD results from a Cirrus Design Corporation (CDC) report of an in-flight Cirrus Airplane Parachute System (CAPS) activation where the parachute failed to successfully deploy. We are issuing this AD to correct pick-up collar support fasteners of the CAPS, which could result in the premature separation of the collar. This condition, if not corrected, could result in the parachute failing to successfully deploy (CAPS failure).
(e) To address this problem, you must do the following, unless already done:
|Replace the pick-up collar support of the CAPS with the new design pick-up collar support and the two nylon collar support screws with new custom aluminum tension screws. One of the following must do the replacement:||Within the next 25 hours time-in-service (TIS) after August 16, 2007 (the effective date of this AD) or within 60 days after August 16, 2007 (the effective date of this AD), whichever occurs first||Follow Cirrus Alert Service Bulletin No. SB A2X-95-10 R2, Issued April 2, 2007, Revised: April 24, 2007.|
|(1) A CDC trained and authorized parachute system technician who also holds an Airframe and Powerplant (A&P) mechanic certificate; or|
|(2) A CDC trained and authorized parachute system technician who is supervised by an A&P mechanic.|
Alternative Methods of Compliance (AMOCs)
(f) The Manager, Chicago Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Wess Rouse, Aerospace Engineer, FAA, 2300 East Devon Avenue, Room 107, Des Plaines, Illinois 60018; telephone: (847) 294-8113; fax: (847) 297-7834. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.
Material Incorporated by Reference
(g) You must use Cirrus Alert Service Bulletin No. SB A2X-95-10 R2, Issued April 2, 2007, Revised: April 24, 2007, or Cirrus Alert Service Bulletin No. SB A2X-95-10 R1, Issued April 2, 2007, Revised: April 10, 2007, to do the actions required by this AD, unless the AD specifies otherwise.
(2) For service information identified in this AD, contact Cirrus Design Corporation, 4515 Taylor Circle, Duluth, Minnesota 55811; telephone: (218) 727-2737; Internet address: www.cirrusdesign.com.
(3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.Start Signature
Issued in Kansas City, Missouri, on June 29, 2007.
Manager, Small Airplane Directorate,Aircraft Certification Service.
[FR Doc. E7-13248 Filed 7-11-07; 8:45 am]
BILLING CODE 4910-13-P