Skip to Content

Rule

Airworthiness Directives; Dassault Model Mystere-Falcon 50 Airplanes

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Final rule.

SUMMARY:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This Airworthiness Directive (AD) is issued following the discovery of a risk of chafing between an electrical feeder bundle and a bus bar under the circuit breaker panel. Most of the time, this possible chafing would be dormant and would lead to an uneventful loss of segregation within the different electrical system components. However, missing segregation combined with additional electrical failures may impair flight safety.

* * * * *

Chafing between an electrical feeder bundle and a bus bar under the circuit breaker panel could lead to electrical arcing, which could result in smoke and fire in the cockpit. We are issuing this AD to require actions to correct the unsafe condition on these products.

DATES:

This AD becomes effective June 12, 2008.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of June 12, 2008.

ADDRESSES:

You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on February 5, 2008 (73 FR 6620). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

This Airworthiness Directive (AD) is issued following the discovery of a risk of chafing between an electrical feeder bundle and a bus bar under the circuit breaker panel. Most of the time, this possible chafing would be dormant and would lead to an uneventful loss of segregation within the different electrical system components. However, missing segregation combined with additional electrical failures may impair flight safety.

This AD mandates inspection of the electrical feeder bundle, and modification of its routing under the circuit breaker panel through implementation of modification M3093.

Chafing between an electrical feeder bundle and a bus bar under the circuit breaker panel could lead to electrical arcing, which could result in smoke and fire in the cockpit.

The corrective action includes repairing or replacing damaged wiring; re-routing the feeder cables above the wiring of the “Avionic Master” and “Aux Bat” relays; installing a protective sheath on the feeder cables; adding spacers to separate the bus bar wiring assemblies from the feeder cables; and adding Teflon protection on the feeder cables and securing the feeder cables with wiring retaining strips. You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ Start Printed Page 25985substantively from the information provided in the MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

Costs of Compliance

We estimate that this AD will affect about 76 products of U.S. registry. We also estimate that it will take about 12 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $80 per work-hour. Required parts will cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $72,960, or $960 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Start List of Subjects

List of Subjects in 14 CFR Part 39

End List of Subjects

Adoption of the Amendment

Start Amendment Part

Accordingly, under the authority delegated to me by the Administrator, the FAA amends

End Amendment Part Start Part

PART 39—AIRWORTHINESS DIRECTIVES

End Part Start Amendment Part

1. The authority citation for part 39 continues to read as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]
Start Amendment Part

2. The FAA amends § 39.13 by adding the following new AD:

End Amendment Part

2008-09-21 Dassault Aviation: Amendment 39-15502. Docket No. FAA-2008-0118; Directorate Identifier 2007-NM-289-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective June 12, 2008.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Dassault Model Mystere-Falcon 50 airplanes, certificated in any category, serial number (S/N) 251 and S/N 253 and subsequent, without modification M3093 implemented.

Subject

(d) Air Transport Association (ATA) of America Code 24: Electrical power.

Reason

(e) The mandatory continuing airworthiness information (MCAI) states:

This Airworthiness Directive (AD) is issued following the discovery of a risk of chafing between an electrical feeder bundle and a bus bar under the circuit breaker panel. Most of the time, this possible chafing would be dormant and would lead to an uneventful loss of segregation within the different electrical system components. However, missing segregation combined with additional electrical failures may impair flight safety.

This AD mandates inspection of the electrical feeder bundle, and modification of its routing under the circuit breaker panel through implementation of modification M3093.

Chafing between an electrical feeder bundle and a bus bar under the circuit breaker panel could lead to electrical arcing, which could result in smoke and fire in the cockpit. The corrective action includes repairing or replacing damaged wiring; re-routing the feeder cables above the wiring of the “Avionic Master” and “Aux Bat” relays; installing a protective sheath on the feeder cables; adding spacers to separate the bus bar wiring assemblies from the feeder cables; and adding Teflon protection on the feeder cables and securing the feeder cables with wiring retaining strips.

Actions and Compliance

(f) Unless already done: Within 13 months after the effective date of this AD, inspect for damage of the electrical feeder bundle; repair or replace wiring, as applicable; and modify its routing as detailed in the accomplishment instructions paragraph of Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007.

FAA AD Differences

Note:

This AD differs from the MCAI and/or service information as follows: No differences.

Other FAA AD Provisions

(g) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority Start Printed Page 25986(or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.

Related Information

(h) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2007-0175, dated June 28, 2007; and Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007; for related information.

Material Incorporated by Reference

(i) You must use Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606.

(3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Start Signature

Issued in Renton, Washington, on April 23, 2008.

Ali Bahrami,

Manager,Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. E8-9895 Filed 5-7-08; 8:45 am]

BILLING CODE 4910-13-P