National Highway Traffic Safety Administration (NHTSA), Department of Transportation.
This final rule announces NHTSA's determination that there are no new model year (MY) 2009 light duty truck lines subject to the parts-marking requirements of the Federal motor vehicle theft prevention standard because they have been determined by the agency to be high-theft or because they have a majority of interchangeable parts with those of a passenger motor vehicle line. This final rule also identifies those vehicle lines that have been granted an exemption from the parts-marking requirements because the vehicles are equipped with antitheft devices determined to meet certain statutory criteria.
Effective Date: The amendment made by this final rule is effective August 15, 2008.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Ms. Rosalind Proctor, Consumer Standards Division, Office of International Policy, Fuel Economy and Consumer Programs, NHTSA, West Building, 1200 New Jersey Avenue, SE., (NVS-131, Room W43-302), Washington, DC 20590. Ms. Proctor's telephone number is (202) 366-0846. Her fax number is (202) 493-0073.End Further Info End Preamble Start Supplemental Information
On April 6, 2004, the agency published in the Federal Register (69 FR 17960) a final rule extending the parts-marking requirements to certain vehicle lines that were not previously subject to these requirements, specifically (1) all low-theft passenger car lines; (2) all low-theft multipurpose passenger vehicle (MPV) lines with a gross vehicle weight rating (GVWR) of 6,000 pounds or less; and (3) low-theft light-duty truck (LDT) lines with a GVWR of 6,000 pounds or less that have major parts that are interchangeable with a majority of the covered major parts of passenger cars or MPVs. The high-theft vehicle lines that were previously exempted under 49 CFR part 543 on the grounds that they were equipped with an antitheft device as standard equipment were unaffected by the April 2004 final rule. The agency also stated that it would continue to grant exemptions for one vehicle line per manufacturer per model year. The final rule was effective September 1, 2006. The final rule included a phase-in provision which required at least 50 percent of the production volume not subject to the current parts marking requirements (excluding light duty trucks) to have been marked by September 1, 2006. The remaining production volume not subject to the current parts marking requirements must have been marked by September 1, 2007 (see 70 FR 28843, May 19, 2005).
The purpose of the theft prevention standard (49 CFR part 541) is to reduce the incidence of motor vehicle theft by facilitating the tracing and recovery of parts from stolen vehicles. The standard seeks to facilitate such tracing by requiring that vehicle identification numbers (VINs), VIN derivative numbers, or other symbols be placed on major component vehicle parts. The theft prevention standard requires motor vehicle manufacturers to inscribe or affix VINs onto covered original equipment major component parts, and to inscribe or affix a symbol identifying the manufacturer and a common symbol identifying the replacement component parts for those original equipment parts, on all vehicle lines subject to the requirements of the standard.
Section 33104(d) provides that once a line has become subject to the theft prevention standard, the line remains subject to the requirements of the standard unless it is exempted under § 33106. Section 33106 provides that a manufacturer may petition to have a line exempted from the requirements of § 33104, if the line is equipped with an antitheft device as standard equipment. The exemption is granted if NHTSA determines that the antitheft device is likely to be as effective as compliance with the theft prevention standard in reducing and deterring motor vehicle thefts.
The agency annually publishes the names of those vehicle lines that have been determined to be high theft pursuant to 49 CFR part 541 and those that are exempted from the theft prevention standard under section 33104. Appendix A to Part 541 identifies those new light-duty truck lines listed for the first time that will be subject to the theft prevention standard beginning in a given model year. Appendix A-I to Part 541 identifies those vehicle lines that are or have been exempted from the theft prevention standard.
On September 26, 2007, the final listing of MY 2008 high-theft vehicle lines was published in the Federal Register (72 FR 54600). The final listing identified that there again were no new vehicle lines that became subject to the theft prevention standard beginning with the 2008 model year. For MY 2009, there were no new light-duty truck lines identified that became subject to the theft prevention standard in accordance with the procedures published in 49 CFR part 542.
For MY 2009, the list of lines that have been exempted by the agency from the parts-marking requirements of Part 541 includes nine vehicle lines newly exempted in full. The nine exempted vehicle lines are the Hyundai Genesis, Mazda 5, Subaru Forester, Jeep Wrangler, Chevrolet Equinox, Daimler smart USA fortwo, Nissan Rogue, Ford Escape, and Audi Q5.
We note that the agency removes from the list being published in the Federal Register each year certain vehicles lines that have been discontinued more than 5 years ago. Therefore, the Chevrolet Lumina/Monte Carlo (1996-1999) and the Chevrolet Malibu (2001-2003) have been removed from the Appendix A-I listing. The agency will continue to maintain a comprehensive database of all exemptions on our Web site. However, we believe that re-publishing a list containing vehicle lines that have not been in production for a considerable period of time is unnecessary.
The vehicle lines listed as being exempt from the standard have previously been exempted in accordance with the procedures of 49 CFR part 543 and 49 U.S.C., 33106. Therefore, NHTSA finds for good cause that notice and opportunity for comment on these listings are unnecessary. Further, public comment on the listing of selections and exemptions is not contemplated by 49 U.S.C. Chapter 331. For the same reasons, since this revised listing only informs the public of previous agency actions and does not impose additional obligations on any party, NHTSA finds for good cause that the amendment made by this notice should be effective as soon as it is published in the Federal Register. Start Printed Page 47848
A. Executive Order 12866 and DOT Regulatory Policies and Procedures
Executive Order 12866, “Regulatory Planning and Review” (58 FR 51735, October 4, 1993), provides for making determinations whether a regulatory action is “significant” and therefore subject to Office of Management and Budget (OMB) review and to the requirements of the Executive Order. The Order defines a “significant regulatory action” as one that is likely to result in a rule that may:
(1) Have an annual effect on the economy of $100 million or more or adversely affect in a material way the economy, a sector of the economy, productivity, competition, jobs, the environment, public health or safety, or State, local, or Tribal governments or communities;
(2) Create a serious inconsistency or otherwise interfere with an action taken or planned by another agency;
(3) Materially alter the budgetary impact of entitlements, grants, user fees, or loan programs or the rights and obligations of recipients thereof; or
(4) Raise novel legal or policy issues arising out of legal mandates, the President's priorities, or the principles set forth in the Executive Order.
This final rule was not reviewed under Executive Order 12866. It is not significant within the meaning of the DOT Regulatory Policies and Procedures. It will not impose any new burdens on vehicle manufacturers. This document informs the public of previously granted exemptions. Since the only purpose of this final rule is to inform the public of previous actions taken by the agency no new costs or burdens will result.
B. Regulatory Flexibility Act
The Regulatory Flexibility Act of 1980 (5 U.S.C. 601 et seq.) requires agencies to evaluate the potential effects of their rules on small businesses, small organizations and small governmental jurisdictions. I have considered the effects of this rulemaking action under the Regulatory Flexibility Act and certify that it would not have a significant economic impact on a substantial number of small entities. As noted above, the effect of this final rule is only to inform the public of agency's previous actions.
C. National Environmental Policy Act
NHTSA has analyzed this final rule for the purposes of the National Environmental Policy Act. The agency has determined that implementation of this action will not have any significant impact on the quality of the human environment. Accordingly, no environmental assessment is required.
D. Executive Order 13132 (Federalism)
The agency has analyzed this rulemaking in accordance with the principles and criteria contained in Executive Order 13132 and has determined that it does not have sufficient federal implications to warrant consultation with State and local officials or the preparation of a federalism summary impact statement.
E. Unfunded Mandates Act
The Unfunded Mandates Reform Act of 1995 requires agencies to prepare a written assessment of the costs, benefits and other effects of proposed or final rules that include a Federal mandate likely to result in the expenditure by State, local or tribal governments, in the aggregate, or by the private sector, of more than $100 million annually ($120.7 million as adjusted annually for inflation with base year of 1995). The assessment may be combined with other assessments, as it is here.
This final rule will not result in expenditures by State, local or tribal governments or automobile manufacturers and/or their suppliers of more than $120.7 million annually. This document informs the public of previously granted exemptions. Since the only purpose of this final rule is to inform the public of previous actions taken by the agency, no new costs or burdens will result.
F. Executive Order 12988 (Civil Justice Reform)
Pursuant to Executive Order 12988, “Civil Justice Reform,” the agency has considered whether this final rule has any retroactive effect. We conclude that it would not have such an effect. In accordance with § 33118 when the Theft Prevention Standard is in effect, a State or political subdivision of a State may not have a different motor vehicle theft prevention standard for a motor vehicle or major replacement part. 49 U.S.C. 33117 provides that judicial review of this rule may be obtained pursuant to 49 U.S.C. 32909. Section 32909 does not require submission of a petition for reconsideration or other administrative proceedings before parties may file suit in court.
G. Paperwork Reduction Act
The Department of Transportation has not submitted an information collection request to OMB for review and clearance under the Paperwork reduction Act of 1995 (Pub. L. 104-13, 44 U.S.C. Chapter 35). This rule does not impose any new information collection requirements on manufacturers.Start List of Subjects
List of Subjects in 49 CFR Part 541
- Administrative practice and procedure
- Motor vehicles
- Reporting and recordkeeping requirements
In consideration of the foregoing,End Amendment Part Start Part
PART 541—[AMENDED]End Part Start Amendment Part
1. The authority citation for part 541 continues to read as follows:End Amendment Part Start Amendment Part
2. In part 541, Appendix A-I is revised to read as follows:End Amendment Part
Appendix A-I to Part 541—Lines With Antitheft Devices Which Are Exempted From the Parts-Marking Requirements of This Standard Pursuant to 49 CFR Part 543
|1 Car Line.|
|3 Car Line.|
|5 Car Line.|
|6 Car Line.|
|7 Car Line.|
|Jeep Grand Cherokee.|
|Start Printed Page 47849|
|Town and Country MPV.|
|FORD MOTOR CO||Escape.1|
|Ford Five Hundred.|
|Lincoln Town Car.|
|Mercury Sable (2001-2004).|
|Mercury Grand Marquis.|
|GENERAL MOTORS||Buick Lucerne.|
|Buick Park Avenue.|
|Chevrolet Impala/Monte Carlo.|
|Chevrolet Malibu/Malibu Maxx.|
|Chevrolet Venture (2002-2004).|
|Pontiac Grand Am.|
|Pontiac Grand Prix.|
|DAIMLER 2||Smart USA Fortwo.1|
|SL-Class (the models within this line are): 300SL, 500SL, 600SL, SL500, SL550, SL600, SL55, SL65.|
|S-Class/CL-Class (the models within this line are): S450, S500, S550, S600, S55, S65, CL500, CL600, CL55, CL65.|
|C-Class/CLK-Class (the models within this line are): C240, C300, C350, CLK 350, CLK 550, CLK 63AMG.|
|E-Class/CLS Class (the models within this line are): E320/E320DT CDi, E350/E500/E55, CLS500/CLS55.|
|Start Printed Page 47850|
|1 Granted an exemption from the parts marking requirements beginning with MY 2009.|
|2 Formerly known as Mercedes-Benz.|
Issued on: August 11, 2008.
Nathaniel M. Beuse,
Office of Crash Avoidance Standards, Director.
[FR Doc. E8-18890 Filed 8-14-08; 8:45 am]
BILLING CODE 4910-59-P