This site displays a prototype of a “Web 2.0” version of the daily Federal Register. It is not an official legal edition of the Federal Register, and does not replace the official print version or the official electronic version on GPO’s govinfo.gov.
The documents posted on this site are XML renditions of published Federal Register documents. Each document posted on the site includes a link to the corresponding official PDF file on govinfo.gov. This prototype edition of the daily Federal Register on FederalRegister.gov will remain an unofficial informational resource until the Administrative Committee of the Federal Register (ACFR) issues a regulation granting it official legal status. For complete information about, and access to, our official publications and services, go to About the Federal Register on NARA's archives.gov.
The OFR/GPO partnership is committed to presenting accurate and reliable regulatory information on FederalRegister.gov with the objective of establishing the XML-based Federal Register as an ACFR-sanctioned publication in the future. While every effort has been made to ensure that the material on FederalRegister.gov is accurately displayed, consistent with the official SGML-based PDF version on govinfo.gov, those relying on it for legal research should verify their results against an official edition of the Federal Register. Until the ACFR grants it official status, the XML rendition of the daily Federal Register on FederalRegister.gov does not provide legal notice to the public or judicial notice to the courts.
Consumer Product Safety Commission.
Notice of Requirements for Accreditation of Third Party Conformity Assessment Bodies To Assess Conformity With Part 1508, Part 1509, and/or Part 1511 of Title 16, Code of Federal Regulations.
Introduction: The Consumer Product Safety Act (“CPSA”), at section 14(a)(3)(B)(ii) as added by section 102(a)(2) of the Consumer Product Safety Improvement Act of 2008 (“CPSIA”), Public Law 110-314, directs the U.S. Consumer Product Safety Commission (“CPSC” or “Commission”) to publish this notice of requirements for accreditation of third party conformity assessment bodies (“third party laboratories”) to test children's products for conformity with the Commission's regulations for full-size baby cribs at 16 CFR part 1508, for non-full-size baby cribs at 16 CFR part 1509, and/or for pacifiers at 16 CFR part 1511.[1 2] Each manufacturer (including the importer) or private labeler of cribs and/or pacifiers subject to those regulations must have products manufactured more than 90 days after the Federal Register publication date of this notice tested by a laboratory accredited to do so and must issue a certificate of compliance with the applicable regulations based on that testing.[3 4]
The Commission is also recognizing limited circumstances in which testing performed by a laboratory on or after May 16, 2008, 90 days prior to the date of enactment of CPSIA (August 14, 2008), but prior to Commission acceptance of the laboratory's preexisting accreditation, provided that accreditation is accepted not later than December 26, 2008, may form the basis for the certificate of compliance with the crib and/or pacifier regulations required of the manufacturer or private labeler.
This notice provides the criteria and process for Commission acceptance of accreditation of “third party” laboratories for testing to the regulations for cribs and/or pacifiers (laboratories that are not owned, managed, or controlled by a manufacturer or private labeler of a children's product to be tested by the laboratory for certification purposes), “firewalled” laboratories (those that are owned, managed, or controlled by a manufacturer or private labeler of a children's product to be tested by the laboratory for certification purposes and that seek accreditation under the additional statutory criteria for “firewalled” laboratories), and laboratories owned or controlled in whole or in part by a government.
The requirements of this notice are effective upon its publication in the Federal Register and are exempted by CPSIA from the notice and comment rulemaking requirements of the Administrative Procedure Act, 5 U.S.C. 553.Start Printed Page 62966
Baseline accreditation of each category of laboratory to the International Organization for Standardization (“ISO”) Standard ISO/IEC 17025:2005—General Requirements for the Competence of Testing and Calibration Laboratories—is required. The accreditation must be by an accreditation body that is a signatory to the International Laboratory Accreditation Cooperation—Mutual Recognition Arrangement (“ILAC-MRA”) and the scope of the accreditation must include testing for compliance with the crib regulations of 16 CFR part 1508 and/or part 1509 and/or the pacifier regulations of part 1511. A laboratory owned or controlled by a manufacturer or private labeler of products to be tested by the laboratory is subject to additional requirements intended to assure that the Commission is immediately and confidentially notified of any attempt by the manufacturer, private labeler or other interested party to hide or exert undue influence over the laboratory's test results. A governmental laboratory may be accredited subject to additional requirements concerning independence of its relationship with the host government and freedom of manufacturers in the host country to elect to use accredited non-government laboratories for certification testing without suffering disadvantage.
The Commission has established an electronic accreditation registration and listing system that can be accessed via its Web site.
Although the accreditation requirements in this notice for testing to the crib and/or pacifier regulations are effective upon their publication in the Federal Register, the Commission solicits comments on the accreditation procedures as they apply to that testing and on the accreditation approach in general, since the Commission must publish additional testing laboratory accreditation procedures over the coming months.
Effective Date: The requirements for accreditation of laboratories for testing to the crib and/or pacifier regulations are effective upon publication of this notice in the Federal Register, that is October 22, 2008.
Request for Comments: Please provide comments in response to this notice by November 21, 2008. Comments on this notice should be captioned “Laboratory Accreditation Process for Crib and Pacifier Testing.” Comments should be submitted to the Office of the Secretary by e-mail at email@example.com, or mailed or delivered, preferably in five copies, to the Office of the Secretary, Consumer Product Safety Commission, 4330 East West Highway, Bethesda, Maryland 20814. Comments may also be filed by facsimile to (301) 504-0127.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Robert “Jay” Howell, Acting Assistant Executive Director for Hazard Identification and Reduction, U.S. Consumer Product Safety Commission, 4330 East West Highway, Bethesda, Maryland 20814; e-mail firstname.lastname@example.org.
I. Accreditation Requirements
A. Baseline Third Party Laboratory Accreditation Requirements
For a third party laboratory to be accredited to test children's products for conformity with the Commission's crib and/or pacifier regulations, it must be accredited by an ILAC-MRA signatory accrediting body and the accreditation must be registered with, and accepted by, the Commission. A listing of ILAC-MRA signatory accrediting bodies is available on the Internet at http://ilac.org/membersbycategory.html. The accreditation must be to ISO Standard ISO/IEC 17025:2005—General Requirements for the Competence of Testing and Calibration Laboratories and the scope of the accreditation must expressly include testing to the regulations of 16 CFR part 1508, 1509, and/or 1511 as applicable to the product(s) to be tested. A true copy of the accreditation and scope documents demonstrating compliance with these requirements must be registered with the Commission electronically. The additional requirements for accreditation of firewalled and governmental laboratories are described below in sections I.B and I.C.
The Commission will maintain on its Web site an up-to-date listing of laboratories whose accreditations it has accepted and the scope of each accreditation. Subject to the limited provisions for acceptance of “retrospective” testing performed by other than firewalled laboratories noted in Section III. below, once the Commission adds a laboratory to that list, the laboratory may commence testing of children's products to support certification by the manufacturer or private labeler of compliance with the crib and/or pacifier regulations, as applicable.
B. Additional Accreditation Requirements for Firewalled Laboratories
In addition to the baseline accreditation requirements in section I.A, firewalled laboratories seeking accredited status must submit to the Commission for review copies of their training documents showing how employees are trained to notify the Commission immediately and confidentially of any attempt by the manufacturer, private labeler or other interested party to hide or exert undue influence over the laboratory's test results. This additional requirement applies to any laboratory in which a manufacturer or private labeler of a children's product to be tested by the laboratory owns a ten percent or more interest. While the Commission is not addressing common parentage of a lab and a children's product manufacturer at this time, it will be vigilant to see if this issue needs to be dealt with in the future.
The Commission must formally accept, by order, the accreditation application of a laboratory before the laboratory can become an accredited firewalled laboratory.
C. Additional Accreditation Requirements for Governmental Laboratories
In addition to the baseline accreditation requirements of section I.A, CPSIA permits accreditation of a laboratory owned or controlled in whole or in part by a government if:
- To the extent practicable, manufacturers or private labelers located in any nation are permitted to choose laboratories that are not owned or controlled by the government of that nation;
- The laboratory's testing results are not subject to undue influence by any other person, including another governmental entity;
- The laboratory is not accorded more favorable treatment than other laboratories in the same nation who have been accredited;
- The laboratory's testing results are accorded no greater weight by other Start Printed Page 62967governmental authorities than those of other accredited laboratories; and
- The laboratory does not exercise undue influence over other governmental authorities on matters affecting its operations or on decisions by other governmental authorities controlling distribution of products based on outcomes of the laboratory's conformity assessments.
The Commission will accept the accreditation of a governmental laboratory if it meets the baseline accreditation requirements of section I.A and meets the conditions stated here. To obtain this assurance, CPSC staff will engage the governmental entities relevant to the accreditation request.
II. How Does a Laboratory Apply for Acceptance of Its Accreditation?
The Commission has established an electronic accreditation acceptance and registration system accessed via the Commission's Internet site at http://www.cpsc.gov/businfo/labaccred.html. The applicant provides basic identifying information concerning its location, the type of accreditation it is seeking, and electronic copies of its ILAC-MRA accreditation certificate and scope statement and firewalled laboratory training document(s), if relevant. Commission staff reviews that submission for accuracy and completeness. In the case of baseline third party laboratory accreditation and accreditation of governmental laboratories, when that review and any necessary discussions with the applicant are satisfactorily completed, the laboratory in question is added to the CPSC listing of accredited laboratories at http://www.cpsc.gov/businfo/labaccred.html. In the case of a firewalled laboratory seeking accredited status, when the review is complete, the staff transmits its recommendation on accreditation to the Commission for consideration. If the Commission accepts a staff recommendation to accredit a firewalled laboratory, that laboratory will then be added to the CPSC list of accredited laboratories. In each case, the Commission will electronically notify the laboratory of acceptance of its accreditation.
Subject to the limited provisions for acceptance of “retrospective” testing performed by other than accredited firewalled laboratories noted in Section III. below, once the Commission adds a laboratory to the list, the laboratory may then commence testing of children's products to support certification of compliance with the crib and/or pacifier regulations, as applicable, by the manufacturer or private labeler.
III. Limited Acceptance of Children's Product Certifications Based on Third Party Laboratory Testing Prior to Commission Acceptance of Accreditation
The Commission will accept a certificate of compliance with the crib and/or pacifier requirements based on testing performed by an accredited third party or governmental laboratory on or after May 16, 2008 (90 days prior to August 14, 2008, the date on which CPSIA was enacted) and thus prior to the Commission's acceptance of the laboratory's accreditation if:
- The laboratory was ISO/IEC 17025 accredited by an ILAC-MRA member at the time of the test;
- The accreditation scope in effect for the laboratory at that time expressly included testing to 16 CFR part 1508, or part 1509, or part 1511, as applicable;
- The laboratory's accreditation application is accepted by the Commission under the procedures of this notice not later than December 26, 2008; and
- The laboratory's accreditation and inclusion of the crib and/or pacifier requirements in its scope remains in effect through the effective date for mandatory third party testing and manufacturer/private labeler certification for cribs and pacifiers.
Testing performed by a firewalled laboratory prior to Commission acceptance of its accreditation cannot be used as the basis for certification by a manufacturer or private labeler with a 10 percent or greater ownership interest in the laboratory pursuant to CPSA section 14(a)(3)(B)(ii) of compliance with the crib and/or pacifier regulations.Start Signature
Dated: October 15, 2008.
Todd A. Stevenson,
Secretary, Consumer Product Safety Commission.
1. Section 102 of CPSIA also required the Commission to publish requirements for accreditation of laboratories for testing to the lead paint ban at 16 CFR part 1303. Those requirements were published in the Federal Register on September 22, 2008. 73 FR 54564-6.
2. Children's products are those designed or intended for use primarily by children 12 years old and younger.Back to Citation
3. Section 14(a)(2) of the CPSA as added by § 102(a)(2) of CPSIA requires that certification be based on testing of sufficient samples of the product, or samples that are identical in all material respects to the product.
4. Of course, irrespective of certification, the children's product in question must comply with applicable CPSC requirements. See, e.g., CPSA § 14(h) as added by CPSIA § 102(b).Back to Citation
5. CPSA section 14(a)(3)(G) as added by section 102(a)(2) of CPSIA exempts publication of this notice from the rulemaking requirements of the Administrative Procedure Act, 5 U.S.C. 553, and from the Regulatory Flexibility Act, 5 U.S.C. 601-612.Back to Citation
6. A description of the history and content of the ILAC-MRA approach and of the requirements of the ISO 17025:2005 laboratory accreditation standard is provided in the CPSC staff briefing memorandum Third Party Conformity Assessment Body Accreditation Requirements for Testing Compliance with 16 CFR Part 1508, Part 1509, and Part 1511 (Cribs and Pacifiers) as Required by the Consumer Product Safety Improvement Act of 2008, October 2008, available on the CPSC Web site at http://cpsc.gov/library/foia/foia09/brief/tpacp.pdf.Back to Citation
7. A laboratory may seek Commission acceptance of accreditation to test only full-size cribs, only non-full-size cribs, or only pacifiers, or some combination thereof. However, required manufacturer certifications may only be based on testing by a laboratory accredited to test the specific product in question.Back to Citation
8. A laboratory that may ultimately seek acceptance as a firewalled laboratory could initially request acceptance as a third party laboratory accredited for testing of children's products other than those of its owners.Back to Citation
[FR Doc. E8-25096 Filed 10-21-08; 8:45 am]
BILLING CODE 6355-01-P