Skip to Content

Notice

Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Metal Furniture Surface Coating, EPA ICR Number 1952.04, OMB Control Number 2060-0518

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Notice.

SUMMARY:

In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR that is abstracted below describes the nature of the collection and the estimated burden and cost.

DATES:

Additional comments may be submitted on or before September 11, 2009.

ADDRESSES:

Submit your comments, referencing docket ID number EPA-HQ-OECA-2008-0429, to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 2201T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

John Schaefer, Office of Air Quality Planning and Standards, Sector Policies and Programs Division (D243-05), Measurement Policy Group, Environmental Protection Agency, Research Triangle Park, North Carolina 27711; telephone number: (919) 541-0296; fax number: (919) 541-3207; e-mail address: schaefer.john@epa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On May 30, 2008 (73 FR 31088), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice.

EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2008-0429, which is available for public viewing online at http://www.regulations.gov, in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744 and the telephone number for the Enforcement and Compliance Docket is (202) 566-1752.

Use EPA's electronic docket and comment system at http://www.regulations.gov to submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select “docket search,” then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov, as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to http://www.regulations.gov.

Title: NESHAP for Metal Furniture Surface Coating (Renewal).

ICR Numbers: EPA ICR Number 1952.04, OMB Control Number 2060-0518.

ICR Status: This ICR is scheduled to expire on September 30, 2009. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB. An Agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB control number. The OMB control numbers for EPA's regulations in title 40 of the CFR, after appearing in the Federal Register when approved, are listed in 40 CFR part 9, and displayed either by publication in the Federal Register or by other appropriate means, such as on the related collection instrument or form, if applicable. The display of OMB control numbers in certain EPA regulations is consolidated in 40 CFR part 9.

Abstract: The National Emission Standards for Hazardous Air Pollutants (NESHAP) for Metal Furniture Surface Coating (40 CFR part 63, subpart RRRR) were proposed on April 24, 2002, and promulgated on May 23, 2003. These regulations apply to existing facilities and new facilities that perform metal furniture surface coating operations where the total Hazardous Air Pollutants (HAPs) emitted are greater than or equal to 10 tons per year of any one HAP; or where the total HAPs emitted are greater than or equal to 25 tons per year of any combination of HAPs.

In general, all NESHAP standards require initial notifications, performance tests, and periodic reports by the owners/operators of the affected facilities. They are also required to maintain records of the occurrence and duration of any startup, shutdown, or malfunction (SSM) in the operation of an affected facility, or any period during which the monitoring system is inoperative. These notifications, reports, and records are essential in determining compliance, and are required of all affected facilities subject to NESHAP.

Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 109 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and Start Printed Page 40581maintaining information, and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements which have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.

Respondents/Affected Entities: Metal furniture surface coating facilities.

Estimated Number of Respondents: 583.

Frequency of Response: Initially, occasionally, and semiannually.

Estimated Total Annual Hour Burden: 190,408.

Estimated Total Annual Cost: $16,826,397, including $16,126,797 in annual labor costs, $699,600 in O&M costs, and no annualized capital/start-up costs.

Changes in the Estimates: There is a change of $400 less for the total estimated Operations and Maintenance (O&M) burden currently identified in the OMB Inventory of Approved ICR Burdens.

Start Signature

Dated: August 6, 2009.

John Moses,

Director, Collection Strategies Division.

End Signature End Supplemental Information

[FR Doc. E9-19302 Filed 8-11-09; 8:45 am]

BILLING CODE 6560-50-P