Skip to Content

Notice

Small Business Size Standards: Waiver of the Nonmanufacturer Rule

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

U.S. Small Business Administration.

ACTION:

Notice of intent to waive the Nonmanufacturer Rule for Woven and Knit impregnated with Flat Dipped Rubber/Plastic Gloves.

SUMMARY:

The U.S. Small Business Administration (SBA) is considering granting a class waiver of the Nonmanufacturer Rule for Glove and Mitten Manufacturing. On August 13, 2010, SBA received a request that a class waiver be granted for woven and knit impregnated with flat dipped rubber/plastic gloves, under the North American Industry Classification System (NAICS) code 315992 (Glove and Mitten Manufacturing). According to the request, no small business manufacturers supply this class of products to the Federal government. Thus, SBA is seeking information on whether there are small business Woven and Knit impregnated with Flat Dipped Rubber/Plastic Gloves manufacturers. If granted, the waiver would allow otherwise qualified small businesses to supply the products of any manufacturer on a Federal contract set aside for small businesses, Service-Disabled Veteran-Owned (SDVO) small businesses or Participants in the SBA's 8(a) Business Development (BD) program.

DATES:

Comments and source information must be submitted September 13, 2010.

ADDRESSES:

You may submit comments and source information to Amy Garcia, Procurement Analyst, Small Business Administration, Office of Government Contracting, 409 3rd Street, SW., Suite 8800, Washington, DC 20416.

Start Further Info Start Printed Page 52790

FOR FURTHER INFORMATION CONTACT:

Ms. Amy Garcia, Procurement Analyst, by telephone at (202) 205-6842; by FAX at (202) 481-1630; or by e-mail at amy.garcia@sba.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Section 8(a)(17) of the Small Business Act (Act), 15 U.S.C. 637(a)(17), and SBA's implementing regulations require that recipients of Federal supply contracts set aside for small businesses, SDVO small businesses, or Participants in the SBA's 8(a) BD Program provide the product of a small business manufacturer or processor, if the recipient is other than the actual manufacturer or processor of the product. This requirement is commonly referred to as the Nonmanufacturer Rule. 13 CFR 121.406(b), 125.15(c). Section 8(a)(17)(b)(iv) of the Act authorizes SBA to waive the Nonmanufacturer Rule for any “class of products” for which there are no small business manufacturers or processors available to participate in the Federal market.

In order to be considered available to participate in the Federal market for a class of products, a small business manufacturer must have submitted a proposal for a contract solicitation or received a contract from the Federal government within the last 24 months. 13 CFR 121.1202(c). The SBA defines “class of products” based on the Office of Management and Budget's NAICS.

The SBA is currently processing a request to waive the Nonmanufacturer Rule for Woven and Knit impregnated with Flat Dipped Rubber/Plastic Gloves, under NAICS code 315992 (Glove and Mitten Manufacturing). The public is invited to comment or provide source information to SBA on the proposed waiver of the Nonmanufacturer Rule for the product within 15 days after date of publication in the Federal Register and on FedBizOpps.gov.

Start Signature

Karen Hontz,

Director, Office of Government Contracting.

End Signature End Supplemental Information

[FR Doc. 2010-21424 Filed 8-26-10; 8:45 am]

BILLING CODE 8025-01-P