Occupational Safety and Health Administration (OSHA), Labor.
Request for public comments.
OSHA solicits public comments concerning its proposal to extend OMB approval of the information collection requirements specified in its Standard on Grain Handling Facilities (29 CFR 1910.272).
Comments must be submitted (postmarked, sent, or received) by April 25, 2011.
Electronically: You may submit comments and attachments electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal. Follow the instructions online for submitting comments.
Facsimile: If your comments, including attachments, are not longer than 10 pages, you may fax them to the OSHA Docket Office at (202) 693-1648.
Mail, hand delivery, express mail, messenger, or courier service: When using this method, you must submit a copy of your comments and attachments to the OSHA Docket Office, OSHA Docket No. OSHA-2011-0028, U.S. Department of Labor, Occupational Safety and Health Administration, Room N-2625, 200 Constitution Avenue, NW., Washington, DC 20210. Deliveries (hand, express mail, messenger, and courier service) are accepted during the Department of Labor's and Docket Office's normal business hours, 8:15 a.m. to 4:45 p.m., e.t.
Instructions: All submissions must include the Agency name and OSHA docket number for the Information Collection Request (ICR) (OSHA-2011-0028). All comments, including any personal information you provide, are placed in the public docket without change, and may be made available online at http://www.regulations.gov. For further information on submitting comments see the “Public Participation” heading in the section of this notice titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the docket, go to http://www.regulations.gov or the OSHA Docket Office at the address above. All documents in the docket (including this Federal Register notice) are listed in the http://www.regulations.gov index; however, some information (e.g., copyrighted material) is not publicly available to read or download through the Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. You may also contact Theda Kenney at the address below to obtain a copy of the ICR.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Theda Kenney or Todd Owen, Directorate of Standards and Guidance, Start Printed Page 9816OSHA, U.S. Department of Labor, Room N-3609, 200 Constitution Avenue, NW., Washington, DC 20210; telephone (202) 693-2222.End Further Info End Preamble Start Supplemental Information
The Department of Labor, as part of its continuing effort to reduce paperwork and respondent (i.e., employer) burden, conducts a preclearance consultation program to provide the public with an opportunity to comment on proposed and continuing information collection requirements in accordance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3506(c)(2)(A)). This program ensures that information is in the desired format, reporting burden (time and costs) is minimal, collection instruments are clearly understood, and OSHA's estimate of the information collection burden is accurate. The Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C. 651 et seq.) authorizes information collection by employers as necessary or appropriate for enforcement of the OSH Act or for developing information regarding the causes and prevention of occupational injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also requires that OSHA obtain such information with minimum burden upon employers, especially those operating small businesses, and to reduce to the maximum extent feasible unnecessary duplication of efforts in obtaining information (29 U.S.C. 657).
The Standard specifies a number of paperwork requirements. The following sections describe who uses the information collected under each requirement as well as how they use it. The purpose of the requirements is to reduce employees' risk of death or serious injury while working in grain handling facilities.
Paragraph (d) of the Standard requires the employer to develop and implement an emergency action plan so that employees will be aware of the appropriate actions to take in the event of an emergency.
Paragraph (e)(1) requires that employers provide training to employees at least annually and when changes in job assignment will expose them to new hazards.
Paragraph (f)(1) requires the employer to issue a permit for all hot work. Under paragraph (f)(2) the permit shall certify that the requirements contained in 1910.272(a) have been implemented prior to beginning the hot work operations and shall be kept on file until completion of the hot work operation.
Paragraph (g)(1)(i) requires the employer to issue a permit for entering bins, silos, or tanks unless the employer or the employer's representative is present during the entire operation. The permit shall certify that the precautions contained in paragraph (g) have been implemented prior to employees entering bins, silos or tanks and shall be kept on file until completion of the entry operations.
Paragraph (g)(1)(ii) requires that the employer deenergize, disconnect, lockout and tag, block-off or otherwise prevent operation of all mechanical, electrical, hydraulic, and pneumatic equipment which presents a danger to employees inside grain storage structures.
Paragraphs (i)(1) and (i)(2) require the employer to inform contractors performing work at the grain handling facility of known potential fire and explosion hazards related to the contractor's work and work area and to explain to the contractor the applicable provisions of the emergency action plan.
Paragraph (j)(1) requires the employer to develop and implement a written housekeeping program that establishes the frequency and method(s) determined best to reduce accumulations of fugitive grain dust on ledges, floors, equipment, and other exposed surfaces.
Under paragraph (m)(1), the employer is required to implement preventive maintenance procedures consisting of regularly scheduled inspections of at least the mechanical and safety control equipment associated with dryers, grain stream processing equipment, dust collection equipment including filter collectors, and bucket elevators. Paragraph (m)(3) requires a certification be maintained of each inspection. Paragraph (m)(4) requires the employer to implement procedures for the use of tags and locks which will prevent the inadvertent application of energy or motion to equipment being repaired, serviced, or adjusted.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
- Whether the proposed information collection requirements are necessary for the proper performance of the Agency's functions, including whether the information is useful;
- The accuracy of OSHA's estimate of the burden (time and costs) of the information collection requirements, including the validity of the methodology and assumptions used;
- The quality, utility, and clarity of the information collected; and
- Ways to minimize the burden on employers who must comply; for example, by using automated or other technological information collection and transmission techniques.
III. Proposed Actions
OSHA is requesting that OMB extend its approval of the information collection requirements contained in the Standard on Grain Handling Facilities (29 CFR 1910.272). The Agency is requesting to reduce its current burden hour estimate associated with this Standard from 70,355 hours to 68,762 hours for a total reduction of 1,593 hours. This adjustment decrease (based on new data obtained by the Agency) is a result of a decline in the number of grain elevators and mills from 19,791 to 19,121. The Agency will summarize the comments submitted in response to this notice and will include this summary in the request to OMB.
Type of Review: Extension of a currently approved collection.
Title: Grain Handling Facilities Standard (29 CFR 1910.272).
OMB Number: 1218-0206.
Affected Public: Business or other for-profits.
Number of Respondents: 18,804.
Total Responses: 1,312,126.
Estimated Time per Response: Varies from 1 minute (.02 hour) to maintain certification records to 3 hours to modify action plans/housekeeping programs/tag and lock procedures.
Total Burden Hours: 68,762.
Estimated Cost (Operation and Maintenance): $0.
IV. Public Participation—Submission of Comments on This Notice and Internet Access to Comments and Submissions
You may submit comments in response to this document as follows: (1) Electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal; (2) by facsimile (fax); or (3) by hard copy. All comments, attachments, and other material must identify the Agency name and the OSHA docket number for the ICR (Docket No. OSHA-2011-0028). You may supplement electronic submissions by uploading document files electronically. If you wish to mail additional materials in reference to an electronic or facsimile submission, you must submit them to the OSHA Docket Office (see the section of this notice titled ADDRESSES). The additional materials must clearly identify your electronic comments by your name, date, and the docket number so the Agency can attach them to your comments.
Because of security procedures, the use of regular mail may cause a significant delay in the receipt of comments. For information about Start Printed Page 9817security procedures concerning the delivery of materials by hand, express delivery, messenger, or courier service, please contact the OSHA Docket Office at (202) 693-2350, (TTY (877) 889-5627).
Comments and submissions are posted without change at http://www.regulations.gov. Therefore, OSHA cautions commenters about submitting personal information such as social security numbers and date of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted material) is not publicly available to read or download through this Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. Information on using the http://www.regulations.gov Web site to submit comments and access the docket is available at the Web site's “User Tips” link. Contact the OSHA Docket Office for information about materials not available through the Web site, and for assistance in using the Internet to locate docket submissions.
V. Authority and Signature
David Michaels, PhD, MPH, Assistant Secretary of Labor for Occupational Safety and Health, directed the preparation of this notice. The authority for this notice is the Paperwork Reduction Act of 1995 (44 U.S.C. 3506 et seq.) and Secretary of Labor's Order No. 4-2010 (75 FR 55355).Start Signature
Signed at Washington, DC, on February 16, 2011.
Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. 2011-3877 Filed 2-18-11; 8:45 am]
BILLING CODE 4510-26-P