Skip to Content


Safety Standard for Toddler Beds

This document is a correction of a document that was published on 04/20/2011. View Uncorrected Document

Document Details

Information about this document as published in the Federal Register.

Document Statistics
Document page views are updated periodically throughout the day and are cumulative counts for this document including its time on Public Inspection. Counts are subject to sampling, reprocessing and revision (up or down) throughout the day.
Enhanced Content

Relevant information about this document from provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


In rule document 2011-9421 beginning on page 22019 in the issue of Wednesday, April 20, 2011, make the following correction:


On page 22029, in § 1217.2(c)(6), at the bottom of the page, insert §§ 1217.2(c)(6)(iii), 1217.2(c)(6)(iv), and 1217.2(c)(7), which should read:

(iii) 8.4.4 Toddler beds that convert from a full-size crib, also known as convertible cribs, must meet the warning requirements specified in section 8 of ASTM F 1169-10, instead of the requirements of 8.4.3. See 16 CFR Part 1219 for complete requirements for full-size cribs.

(iv) 8.4.5 Any toddler bed that can convert from a full-size crib, and has the warning specified in section 8.1.3 of ASTM F 1169-10, must include additional text at the end of that warning that specifies the minimum mattress thickness of 4 inches (100 mm). See 16 CFR Part 1219 for complete requirements for full-size cribs.

(7) In addition to figure 10 of ASTM F 1821-09, use the following:

End Preamble

[FR Doc. C1-2011-9421 Filed 5-12-11; 8:45 am]