Skip to Content

Notice

Reports, Forms, and Recordkeeping Requirements

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble Start Printed Page 35270

AGENCY:

National Highway Traffic Safety Administration (NHTSA), Department of Transportation.

ACTION:

Request for public comment on a reinstatement of a previously approved collection of information.

SUMMARY:

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections.

This document describes one collection of information for parts 541, 565, and 567 for which NHTSA intends to seek OMB approval.

DATES:

Comments must be received on or before August 15, 2011.

ADDRESSES:

You may submit comments [identified by DOT Docket No. NHTSA-2011-0025] by any of the following methods:

  • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting comments.
  • Mail: Docket Management Facility: U.S. Department of Transportation, 1200 New Jersey Avenue, SE., West Building, Ground Floor, Room W12-140, Washington, DC 20590-0001.
  • Hand Delivery or Courier: West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m. ET, Monday through Friday, except Federal holidays.
  • Fax: 1-202-493-2251.
  • You may call the Docket at (202) 366-9324.

Regardless of how you submit your comments, you should mention the docket number of this document. Please identify the proposed collection of information for which a comment is provided, by referencing its OMB clearance number. It is requested, but not required, that two copies of the comment be provided.

Instructions: For detailed instructions on submitting comments and additional information on the rulemaking process, see the Public Participation heading of the Supplementary Information section of this document. Note that all comments received will be posted without change to http://www.regulations.gov, including any personal information provided. Anyone is able to search the electronic form of all comments received into any of our dockets by the name of the individual submitting the comment (or signing the comment, if submitted on behalf of an association, business, labor union, etc.). You may review DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).

Docket: For access to the docket to read background documents or comments received, go to the street address listed above. The Internet access to the docket will be at http://www.regulations.gov. Follow the online instructions for accessing the dockets.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Complete copies of each request for collection of information may be obtained at no charge from Ms. Deborah Mazyck, NHTSA, 1200 New Jersey Avenue, SE., West Building, Room W43-443, Washington, DC 20590. Ms. Mazyck's telephone number is (202) 366-4139 and e-mail address is Deborah.Mazyck@dot.gov. Please identify the relevant collection of information by referring to its OMB Control Number.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Under the Paperwork Reduction Act of 1995, before an agency submits a proposed collection of information to OMB for approval, it must first publish a document in the Federal Register providing a 60-day comment period and otherwise consult with members of the public and affected agencies concerning each proposed collection of information. The OMB has promulgated regulations describing what must be included in such a document. Under OMB's regulation (at 5 CFR 1320.8(d), an agency must ask for public comment on the following:

(i) Whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility;

(ii) The accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used;

(iii) How to enhance the quality, utility, and clarity of the information to be collected;

(iv) How to minimize the burden of the collection of information on those who are to respond, including the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g. permitting electronic submission of responses.

In compliance with these requirements, NHTSA asks for public comments on the following request for reinstatement of a previously approved collection of information:

Title: Consolidated Labeling Requirements for 49 CFR 541, 565 and 567.

OMB Control Number: 2127-0510.

Form Number: None.

Affected Public: Vehicle manufacturers.

Requested Expiration Date of Approval: Three years from the approval date.

Abstract: For parts 541, 565 and 567.

Part 541

The Motor Vehicle Information and Cost Savings Act was amended by the Anti-Car Theft Act of 1992 (Pub. L. 102-519). The enacted Theft Act requires specified parts of high-theft vehicle to be marked with vehicle identification numbers. In a final rule published on April 6, 2004, the Federal Motor Vehicle Theft Prevention Standard was extended to include all passenger cars and multipurpose passenger vehicles with a gross vehicle weight rating of 6,000 pounds or less, and to light duty trucks with major parts that are interchangeable with a majority of the covered major parts of multipurpose passenger vehicles. Each major component part must be either labeled or affixed with the VIN and its replacement component part must be marked with the DOT symbol, the letter (R) and the manufacturers' logo. The final rule became effective September 1, 2006. Due to expansion of the Federal Motor Vehicle Theft Prevention Standard (part 541), all passenger cars, and multipurpose passenger vehicles with a gross vehicle weight rating of 6,000 pounds or less, and light duty trucks with major parts that are interchangeable with a majority of the covered major parts of multipurpose passenger vehicles, are required to be parts marked.

NHTSA estimates the vehicle manufacturers will incur a total cost burden of $122,138,000 million.

Parts 565 and 567

NHTSA's statute at 15 U.S.C. 1392, 1397, 1401, 1407, and 1412 of the National Traffic and Motor Vehicle Safety Act of 1966 authorizes the issuance of Federal Motor Vehicle Safety Standard (FMVSS) and the Start Printed Page 35271collection of data which support their implementation. The agency, in prescribing an FMVSS, is to consider available relevant motor vehicle safety data and to consult with other agencies as it deems appropriate. Further, the Act mandates, that in issuing any FMVSS, the agency should consider whether the standard is reasonable, practicable and appropriate for the particular type of motor vehicle or item of motor vehicle equipment for which it is prescribed, and whether such standards will contribute to carrying out the purpose of the Act. The Secretary is authorized to revoke such rules and regulations as deemed necessary to carry out this subchapter. Using this authority, the agency issued the initial FMVSS No. 115, Vehicle Identification Number, specifying requirements for vehicle identification numbers to aid the agency in achieving many of its safety goals.

The standard was amended in August 1978 by extending its applicability to additional classes of motor vehicles and by specifying the use of a 30-year, 17-character Vehicle Identification Number (VIN) for worldwide use. The standard was amended in May 1983 by deleting portions of FMVSS No. 115 and reissuing those portions as a general agency regulation, part 565. Subsequently, the standard was amended again in June 1996 transferring the text of the FMVSS No. 115 to part 565, without making any substantive changes to the VIN requirements as a result of the proposed consolidation. The provision of the part 565 (amended) regulation requires vehicle manufacturers to assign a unique VIN to each new vehicle and to inform NHTSA of the code used in forming the VIN. These regulations apply to all vehicles: Passenger cars, multipurpose passenger vehicles, trucks, buses, trailers, incomplete vehicles, and motorcycles.

NHTSA has amended to part 565 to revise certain sections in order to extend the existing VIN system for another thirty years, and to ensure a sufficient supply of unique available VINs and manufacturer identifiers for that time period (72 FR 56027, October 2, 2007). The agency required information to be provided in a slightly different way (e.g., vehicle make being transferred from the first to the second section of the VIN), the scope of the overall reporting requirement of part 565 will not change.

Part 567 specifies the content and location of, and other requirements for, the certification label or tag to be affixed to motor vehicles and motor vehicle equipment. Specifically, the VIN is required to appear on the certification label. Additionally, this certificate will provide the consumer with information to assist him or her in determining which of the Federal Motor Vehicle Safety Standards are applicable to the vehicle or equipment, and its date of manufacturer.

NHTSA estimates a cost burden of $13,348,000 for this requirement.

Estimated Annual Burden: The overall total estimated annual hour burden for this collection is 798,047. The overall total estimated cost burden for this collection is $122,138,000 million.

Number of Respondents: The total number of respondents for this collection (part 541, 565 and part 567) is 1,104.

Comments are invited on: Whether the proposed collection of information is necessary for the proper performance of the functions of the Department, including whether the information will have practical utility; the accuracy of the Department's estimate of the burden of the proposed information collection; ways to enhance the quality, utility and clarity of the information to be collected; and ways to minimize the burden of the collection of information on respondents, including the use of automated collection techniques or other forms of information technology.

Start Signature

Issued on: June 10, 2011.

Christopher J. Bonanti,

Associate Administrator for Rulemaking.

End Signature End Supplemental Information

[FR Doc. 2011-14993 Filed 6-15-11; 8:45 am]

BILLING CODE 4910-59-P