The Food and Drug Administration (FDA) is announcing that a proposed collection of information has been submitted to the Office of Management and Budget (OMB) for review and clearance under the Paperwork Reduction Act of 1995.
Fax written comments on the collection of information by August 13, 2012.
To ensure that comments on the information collection are received, OMB recommends that written comments be faxed to the Office of Information and Regulatory Affairs, OMB, Attn: FDA Desk Officer, Fax: 202-395-7285, or emailed to firstname.lastname@example.org. All comments should be identified with the OMB control number 0910-0594. Also include the FDA docket number found in brackets in the heading of this document.
FOR FURTHER INFORMATION CONTACT:
Ila S. Mizrachi, Office of Information Management, Food and Drug Administration, 1350 Piccard Dr., PI50-400B, Rockville, MD 20850, 301-796-7726, Ila.Mizrachi@fda.hhs.gov.
In compliance with 44 U.S.C. 3507, FDA has submitted the following proposed collection of information to OMB for review and clearance.
Guidance for Industry and Food and Drug Administration Staff; Class II Special Controls Guidance Document: Automated Blood Cell Separator Device Operating by Centrifugal or Filtration Separation Principle (OMB Control Number 0910-0594)—Extension
Under the Safe Medical Devices Act of 1990 (Pub. L. 101-629), FDA may establish special controls, including performance standards, postmarket surveillance, patient registries, guidelines, and other appropriate actions it believes necessary to provide reasonable assurance of the safety and effectiveness of the device.
The special control guidance serves to support the reclassification from class III to class II of the automated blood cell separator device operating on a centrifugal separation principle intended for the routine collection of blood and blood components as well as the special control for the automated blood cell separator device operating on a filtration separation principle intended for the routine collection of blood and blood components reclassified as class II (§ 864.9245 (21 CFR 864.9245)).
For currently marketed products not approved under the premarket approval process, the manufacturer should file with FDA for 3 consecutive years an annual report on the anniversary date of the device reclassification from class III to class II or, on the anniversary date of the 510(k) of the Federal Food, Drug, and Cosmetic Act (the FD&C Act) (21 U.S.C. 360) clearance. Any subsequent change to the device requiring the submission of a premarket notification in accordance with section 510(k) of the FD&C Act should be included in the annual report. Also, a manufacturer of a device determined to be substantially equivalent to the centrifugal or filtration-based automated cell separator device intended for the routine collection of blood and blood components, should comply with the same general and special controls.
The annual report should include, at a minimum, a summary of anticipated and unanticipated adverse events that have occurred and that are not required to be reported by manufacturers under Medical Device Reporting (MDR) (part 803 (21 CFR part 803)). The reporting of adverse device events summarized in an annual report will alert FDA to trends or clusters of events that might be a safety issue otherwise unreported under the MDR regulation.
Reclassification of this device from class III to class II for the intended use of routine collection of blood and blood components relieves manufacturers of the burden of complying with the premarket approval requirements of section 515 of the FD&C Act (21 U.S.C. 360e), and may permit small potential competitors to enter the marketplace by reducing the burden. Although the special control guidance recommends that manufacturers of these devices file with FDA an annual report for 3 consecutive years, this would be less burdensome than the current postapproval requirements under part 814, subpart E (21 CFR part 814, subpart E), including the submission of periodic reports under § 814.84.
Collecting or transfusing facilities, and manufacturers have certain responsibilities under the Federal regulations. For example, collecting or transfusing facilities are required to maintain records of any reports of complaints of adverse reactions (21 CFR 606.170), while the manufacturer is responsible for conducting an investigation of each event that is reasonably known to the manufacturer and evaluating the cause of the event (§ 803.50(b)). In addition, manufacturers of medical devices are required to submit to FDA individual adverse event reports of death, serious injury, and malfunctions (§ 803.50).
In the special control guidance document, FDA recommends that manufacturers include in their three annual reports a summary of adverse reactions maintained by the collecting or transfusing facility or similar reports of adverse events collected in addition to those required under the MDR regulation. The MedWatch medical device reporting code instructions (http://www.fda.gov/MedicalDevices/DeviceRegulationandGuidance/GuidanceDocuments/ucm106737.htm) contains a comprehensive list of adverse events associated with device use, including most of those events that we recommend summarizing in the annual report.
In the Federal Register of February 15, 2012 (77 FR 8879), FDA published a 60-day notice requesting public comment on the proposed collection of information. No comments were received.
FDA estimates the burden of this collection of information as follows:
Table 1—Estimated Annual Reporting Burden1
|Reporting activity||Number of respondents||Number of responses per respondent||Total annual responses||Average burden per
|1 There are no capital costs or operating and maintenance costs associated with this collection of information.|
Based on FDA records, there are approximately four manufactures of automated blood cell separator devices. We estimate that the manufacturers will spend approximately 5 hours preparing and submitting the annual report.
Other burden hours required for § 864.9245 are reported and approved under OMB control number 0910-0120 (premarket notification submission 501(k), 21 CFR part 807, subpart E), and OMB control number 0910-0437 (MDR, 21 CFR part 803).
Dated: July 6, 2012.
Assistant Commissioner for Policy.
[FR Doc. 2012-17080 Filed 7-12-12; 8:45 am]
BILLING CODE 4160-01-P