Skip to Content


The Commerce Control List

Document Details

Information about this document as published in the Federal Register.

Document Statistics
Document page views are updated periodically throughout the day and are cumulative counts for this document including its time on Public Inspection. Counts are subject to sampling, reprocessing and revision (up or down) throughout the day.
Enhanced Content

Relevant information about this document from provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

CFR Correction

In Title 15 of the Code of Federal Regulations, Parts 300 to 799, revised as of January 1, 2012, in supplement no. 1 to part 774, make the following corrections:

1. In Category 7:

A. On page 838, in 7A002, under the table in “Licensing Requirements”, add a “License Requirements Note” as set forth below.

B. On page 839, in 7A005, above “License Requirements”, remove the Note to 7A005.

C. On page 840, in 7A008, add “License Requirements” above “Reason for Control”.

D. On page 843, in 7B101, in the heading, add a quotation mark before “Production”.

E. On page 847, in 7E003, at the end of “Related Definition”, add “for `Maintenance Level I' or `Maintenance Level II'”.

2. In Category 9, on page 870, in 9E003, below paragraph a.10, remove Note 1 and Note 2.

The text to be added is set forth below:

Supplement No. 1 to Part 774—The Commerce Control List

* * * * *

Category 7

* * * * *

7A002 Gyros or angular rate sensors, having any of the following see List of Items Controlled) and specially designed components therefor.

* * * * *

License Requirement Note: For the purpose of MT controls only, the term `stability' is defined as a measure of the ability of a specific mechanism or performance coefficient to remain invariant when continuously exposed to a fixed operating condition. (This definition does not refer to dynamic or servo stability.) (IEEE STD 528-2001 paragraph 2.247)

* * * * *

[FR Doc. 2012-19389 Filed 8-6-12; 8:45 am]