Federal Aviation Administration (FAA), DOT.
Notice of proposed rulemaking (NPRM).
This action proposes to amend Class E airspace at Reno/Tahoe International Airport, Reno, NV. Decommissioning of the Compass Locator at the Instrument Landing System Middle Marker (LMM) and the Middle Marker (MM) has made this action necessary for the safety and management of Instrument Flight Rules (IFR) operations at the airport. This action also would adjust the geographic coordinates of the airport.
Comments must be received on or before March 11, 2013.
Send comments on this proposal to the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590; telephone (202) 366-9826. You must identify FAA Docket No. FAA-2012-1195; Airspace Docket No. 12-AWP-7, at the beginning of your comments. You may also submit comments through the Internet at http://www.regulations.gov.
Start Further Info
FOR FURTHER INFORMATION CONTACT:
Eldon Taylor, Federal Aviation Administration, Operations Support Group, Western Service Center, 1601 Lind Avenue SW., Renton, WA 98057; telephone (425) 203-4537.
End Further Info
Start Supplemental Information
Interested parties are invited to participate in this proposed rulemaking by submitting such written data, views, or arguments, as they may desire. Comments that provide the factual basis supporting the views and suggestions presented are particularly helpful in developing reasoned regulatory decisions on the proposal. Comments are specifically invited on the overall regulatory, aeronautical, economic, environmental, and energy-related aspects of the proposal.
Communications should identify both docket numbers (FAA Docket No. FAA 2012-1195 and Airspace Docket No. 12-AWP-7) and be submitted in triplicate Start Printed Page 5154to the Docket Management System (see ADDRESSES section for address and phone number). You may also submit comments through the Internet at http://www.regulations.gov.
Commenters wishing the FAA to acknowledge receipt of their comments on this action must submit with those comments a self-addressed stamped postcard on which the following statement is made: “Comments to FAA Docket No. FAA-2012-1195 and Airspace Docket No. 12-AWP-7”. The postcard will be date/time stamped and returned to the commenter.
All communications received on or before the specified closing date for comments will be considered before taking action on the proposed rule. The proposal contained in this action may be changed in light of comments received. All comments submitted will be available for examination in the public docket both before and after the closing date for comments. A report summarizing each substantive public contact with FAA personnel concerned with this rulemaking will be filed in the docket.
Availability of NPRMs
An electronic copy of this document may be downloaded through the Internet at http://www.regulations.gov. Recently published rulemaking documents can also be accessed through the FAA's Web page at http://www.faa.gov/airports_airtraffic/air_traffic/publications/airspace_amendments/.
You may review the public docket containing the proposal, any comments received, and any final disposition in person in the Dockets Office (see the ADDRESSES section for the address and phone number) between 9:00 a.m. and 5:00 p.m., Monday through Friday, except federal holidays. An informal docket may also be examined during normal business hours at the Northwest Mountain Regional Office of the Federal Aviation Administration, Air Traffic Organization, Western Service Center, Operations Support Group, 1601 Lind Avenue SW., Renton, WA 98057.
Persons interested in being placed on a mailing list for future NPRMs should contact the FAA's Office of Rulemaking, (202) 267-9677, for a copy of Advisory Circular No. 11-2A, Notice of Proposed Rulemaking Distribution System, which describes the application procedure.
The FAA is proposing an amendment to Title 14 Code of Federal Regulations (14 CFR) Part 71 by amending Class E airspace designated as an extension to Class C airspace area for Reno/Tahoe International Airport, Reno, NV. Airspace reconfiguration is necessary due to the decommissioning of the LMM and the MM navigation aids. The Airport Reference Point (ARP) would be used to describe the airspace instead of the LMM and the MM navigational aids. There would be no change in the current configuration of the controlled airspace area. Also, the geographic coordinates of the airport would be updated to coincide with the FAA's aeronautical database. Controlled airspace is necessary for the safety and management of IFR operations at the airport.
Class E airspace designations are published in paragraph 6003, of FAA Order 7400.9W, dated August 8, 2012, and effective September 15, 2012, which is incorporated by reference in 14 CFR part 71.1. The Class E airspace designation listed in this document will be published subsequently in this Order.
The FAA has determined this proposed regulation only involves an established body of technical regulations for which frequent and routine amendments are necessary to keep them operationally current. Therefore, this proposed regulation; (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034; February 26, 1979); and (3) does not warrant preparation of a regulatory evaluation as the anticipated impact is so minimal. Since this is a routine matter that will only affect air traffic procedures and air navigation, it is certified this proposed rule, when promulgated, would not have a significant economic impact on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
The FAA's authority to issue rules regarding aviation safety is found in Title 49 of the U.S. Code. Subtitle 1, Section 106, describes the authority for the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the agency's authority. This rulemaking is promulgated under the authority described in Subtitle VII, Part A, Subpart I, Section 40103. Under that section, the FAA is charged with prescribing regulations to assign the use of the airspace necessary to ensure the safety of aircraft and the efficient use of airspace. This regulation is within the scope of that authority as it would amend controlled airspace at Reno/Tahoe International Airport, Reno, NV.
This proposal will be subject to an environmental analysis in accordance with FAA Order 1050.1E, “Environmental Impacts: Policies and Procedures” prior to any FAA final regulatory action.
Start List of Subjects
End List of Subjects
- Incorporation by reference
- Navigation (air)
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me, the Federal Aviation Administration proposes to amend 14 CFR part 710 as follows:
PART 71—DESIGNATION OF CLASS A, B, C, D AND E AIRSPACE AREAS; AIR TRAFFIC SERVICE ROUTES; AND REPORTING POINTS
Start Amendment Part
1. The authority citation for 14 CFR part 71 continues to read as follows:End Amendment Part
Start Amendment Part
2. The incorporation by reference in 14 CFR Part 71.1 of the Federal Aviation Administration Order 7400.9W, Airspace Designations and Reporting Points, dated August 8, 2012, and effective September 15, 2012 is amended as follows:End Amendment Part
Paragraph 6003 Class E airspace designated as an extension to class C surface areas.
* * * * *
AWP NV E3 Reno, NV [Amended]
Reno/Tahoe International Airport, NV
(Lat. 39°29′57″ N., long. 119°46′05″ W.)
That airspace extending upward from the surface within 1.8 miles each side of the Reno/Tahoe International Airport 360° bearing extending from the 5-mile radius of the airport to 12 miles north of the airport, and within 1.8 miles each side of the Reno/Tahoe International Airport 180° bearing extending from the 5-mile radius of the airport to 10.5 miles south of the airport.
End Supplemental Information
Issued in Seattle, Washington, on December 6, 2012.
Manager, Operations Support Group, Western Service Center.
[FR Doc. 2013-01310 Filed 1-23-13; 8:45 am]
BILLING CODE 4910-13-P