Skip to Content

Rule

Airworthiness Directives; The Boeing Company Airplanes

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Final rule.

SUMMARY:

We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 727 airplanes. This AD was prompted by reports of cracks on the elevator rear spar stiffener assembly. This AD requires repetitive detailed inspections for cracking of the elevator rear spar stiffener assembly, and corrective actions if necessary. We are issuing this AD to detect and correct cracking of the elevator rear spar stiffener assembly, which could adversely affect elevator structural stiffness, which could lead to elevator vibration and possible interference with the tab control rod. These conditions could result in flutter and consequent loss of control of the airplane.

DATES:

This AD is effective August 26, 2013.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in the AD as of August 26, 2013.

ADDRESSES:

For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the Docket Office (phone: 800-647-5527) is Document Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Berhane Alazar, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6577; fax: 425-917-6590; email: berhane.alazar@faa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. The NPRM published in the Federal Register on April 11, 2013 (78 FR 21569). The NPRM proposed to require Start Printed Page 43771repetitive detailed inspections for cracking of the elevator rear spar stiffener assembly.

Comments

We gave the public the opportunity to participate in developing this AD. We have considered the comments received.

Supportive Comments

Boeing stated that it supports the NPRM (78 FR 21569, April 11, 2013).

FedEx stated that the requirements proposed in the NPRM (78 FR 21569, April 11, 2013) would fit within the planned scheduled maintenance check and not impact fleet availability or span-time of the planned scheduled maintenance check.

Conclusion

We reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:

  • Are consistent with the intent that was proposed in the NPRM (78 FR 21569, April 11, 2013) for correcting the unsafe condition; and
  • Do not add any additional burden upon the public than was already proposed in the NPRM (78 FR 21569, April 11, 2013).

Costs of Compliance

We estimate that this AD affects 98 airplanes of U.S. registry. We estimate the following costs to comply with this AD:

Estimated costs

ActionLabor costParts costCost per productCost on U.S. operators
Inspection5 work-hours × $85 per hour = $425 per inspection cycleNone$425 per inspection cycle$41,650 per inspection cycle

We estimate the following costs to do any necessary replacements that would be required based on the results of the inspection. We have no way of determining the number of aircraft that might need this replacement:

On-condition costs

ActionLabor costParts costCost per product
Replacement7 work-hours × $85 per hour = $595Unknown$595

Authority for this Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Start List of Subjects

List of Subjects in 14 CFR Part 39

End List of Subjects

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

Start Part

PART 39—AIRWORTHINESS DIRECTIVES

End Part Start Amendment Part

1. The authority citation for part 39 continues to read as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]
Start Amendment Part

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

End Amendment Part

2013-14-03 The Boeing Company: Amendment 39-17508 ; Docket No. FAA-2013-0299; Directorate Identifier 2012-NM-072-AD.

(a) Effective Date

This AD is effective August 26, 2013.

(b) Affected ADs

None.

(c) Applicability

This AD applies to all The Boeing Company Model 727, 727C, 727-100, 727-100C, 727-200, and 727-200F series airplanes, certificated in any category.

(d) Subject

Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 55, Stabilizers.

(e) Unsafe Condition

This AD was prompted by reports of cracks on the elevator rear spar stiffener assembly. We are issuing this AD to detect and correct cracking of the elevator rear spar stiffener assembly, which could adversely affect elevator structural stiffness, which could lead to elevator vibration and possible interference with the tab control rod. These conditions could result in elevator flutter and consequent loss of control of the airplane.Start Printed Page 43772

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Repetitive Inspections and Corrective Actions

Except as provided by paragraph (h) of this AD, at the applicable time specified in table 1 of paragraph 1.E., “Compliance,” of Boeing Special Attention Service Bulletin 727-55-0094, dated March 21, 2012, do a detailed inspection for any cracking of the elevator rear spar stiffener assembly, and all applicable corrective actions, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 727-55-0094, dated March 21, 2012. Do all applicable corrective actions before further flight. Repeat the inspection thereafter at the applicable time specified in table 1 of paragraph 1.E., “Compliance,” of Boeing Special Attention Service Bulletin 727-55-0094, dated March 21, 2012, except as provided by paragraph (j) of this AD.

(h) Exception to the Service Information

Where Boeing Special Attention Service Bulletin 727-55-0094, dated March 21, 2012, specifies a compliance time “from the original issue date of this service bulletin,” this AD requires compliance within the specified compliance time after the effective date of this AD.

(i) Optional Replacement

Replacing the elevator rear spar stiffener assembly with a new assembly in accordance with Part 4 or 5, as applicable, of the Accomplishment Instructions of Boeing Special Attention Service Bulletin 727-55-0094, dated March 21, 2012, terminates the inspections required by paragraph (g) of this AD for that assembly, except as required by paragraph (j) of this AD.

(j) Post-Replacement Inspection Compliance Time

For any elevator rear spar stiffener assembly replaced as required by paragraph (g) of this AD or as specified in paragraph (i) of this AD: Do the next inspection required by paragraph (g) of this AD for that assembly within 96 months after accomplishing the replacement and repeat thereafter at the times specified in paragraph (g) of this AD.

(k) Alternative Methods of Compliance (AMOCs)

(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in the Related Information section of this AD. Information may be emailed to: 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD.

(l) Related Information

For more information about this AD, contact Berhane Alazar, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6577; fax: 425-917-6590; email: berhane.alazar@faa.gov.

(m) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.

(i) Boeing Special Attention Service Bulletin 727-55-0094, dated March 21, 2012.

(ii) Reserved.

(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com.

(4) You may view this service information at FAA, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Start Signature

Issued in Renton, Washington, on June 21, 2013.

Jeffrey E. Duven,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. 2013-16930 Filed 7-19-13; 8:45 am]

BILLING CODE 4910-13-P