This PDF is the current document as it appeared on Public Inspection on 07/19/2013 at 08:45 am.
National Highway Traffic Safety Administration, DOT.
Grant of petition.
BMW of North America, LLC  a subsidiary of BMW AG. has determined that certain model year (MY) 2012 BMW X6M SAV multipurpose passenger vehicles (MPV) manufactured between April 1, 2011 and March 23, 2012, do not fully comply with paragraph S4.3 (b) of Federal Motor Vehicle Safety Standard (FMVSS) No. 110, Tire selection and rims and motor home/recreation vehicle trailer load carrying capacity information for motor vehicles with a GVWR of 4,536 kilograms (10,000 pounds) or less. BMW has filed an appropriate report dated April 4, 2012, Start Printed Page 43965pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.
Pursuant to 49 U.S.C. 30118(d) and 30120(h) and the rule implementing those provisions at 49 CFR part 556, BMW has petitioned for an exemption from the notification and remedy requirements of 49 U.S.C. Chapter 301 on the basis that this noncompliance is inconsequential to motor vehicle safety. Notice of receipt of the petition was published, with a 30-day public comment period, on June 25, 2012 in the Federal Register (77 FR 37956.) No comments were received. To view the petition and all supporting documents log onto the Federal Docket Management System (FDMS) Web site at: http://www.regulations.gov/. Then follow the online search instructions to locate docket number “NHTSA-2012-0075.”
Contact Information: For further information on this decision contact Ms. Amina Fisher, Office of Vehicle Safety Compliance, the National Highway Traffic Safety Administration (NHTSA), telephone (202) 366-1018, facsimile (202) 366-5930.
Vehicles Involved: Affected are approximately 364 MY 2012 BMW X6M SAV MPVs manufactured between April 1, 2011 and March 23, 2012.
Rule Text: Section S4.3(b) of FMVSS No. 110 specifically states:
S4.3 (b) Placard. Each vehicle, except for a trailer or incomplete vehicle, shall show the information specified in S4.3(a) through (g), and may show, at the manufacturer's option, the information specified in S4.3(h) and (i), on a placard permanently affixed to the driver's side B-pillar. * * *
b) Designated seated capacity (expressed in terms of total number of occupants and number of occupants for each front and rear seat location); * * *
Summary of BMW'S Analyses: BMW explains that the noncompliance is that the tire placard on the affected vehicles incorrectly identifies the rear designated seating capacity as “2” when in fact it should be “3,” and the total designated seating capacity as “4” when in fact it should be “5.”
BMW states that while the tire placard incorrectly identifies the vehicle seating capacity, this noncompliance is inconsequential to motor vehicle safety for the following reasons:
1. It would become clear to a vehicle owner that the rear seat of the affected vehicles contains three sets of seat belts, and provides adequate space for three people to occupy the rear seat and that the vehicle in fact does accommodate five passengers not four as labeled.
2. The tire pressure value on the tire placard is correct. In fact, the recommended tire inflation pressure for both the five passenger and the four passenger vehicles is the same. Therefore, there is no risk of under-inflation.
3. The vehicle capacity weight listed on the tire placard is correct, and is the same for X6M model vehicles built for four or five occupants. Therefore, there is no risk of overloading.
4. The vehicle's Monroney label contains a listing of all options that have been equipped on the affected vehicles. The option regarding the rear seat for three occupants is noted on the Monroney label; therefore, an owner would have been notified at time of purchase of the vehicle that the rear seat is equipped to accommodate three occupants.
5. The vehicle Owner's Manual contains information pertaining to the vehicle's tires, tire pressure, and the vehicle capacity weight. Therefore, if owners check the Owner's Manual, correct information is available for their use.
6. BMW also offers Roadside AssistanceTM and BMW AssistTM which are available 24 hours/day with representatives that are available to provide drivers with all of the available tires sizes and specifications for the affected vehicles.
7. BMW has received no customer complaints and are unaware of any accidents or injuries regarding this noncompliance of the affected vehicles.
BMW has additionally informed NHTSA that it has corrected future production and that all other required markings are present and correct.
BMW also expressed its belief that NHTSA has previously granted similar petitions.
In summation, BMW believes that the described noncompliance of the subject vehicles is inconsequential to motor vehicle safety, and that its petition, to exempt from providing recall notification of noncompliance as required by 49 U.S.C. 30118 and remedying the recall noncompliance as required by 49 U.S.C. 30120 should be granted.
NHTSA Decision: NHTSA has reviewed and accepts BMW's analyses that the noncompliance is inconsequential to motor vehicle safety. BMW has provided sufficient documentation that other than the labeling error, the vehicles comply with all other safety performance requirements of FMVSS No. 110. Since the correct information is provided in other locations, BMW has met its burden of persuasion. Accordingly, BMW's petition is hereby granted, and BMW is exempted from the obligation of providing notification of, and a remedy for, that noncompliance under 49 U.S.C. 30118 and 30120.
NHTSA notes that the statutory provisions (49 U.S.C. 30118(d) and 30120(h)) that permit manufacturers to file petitions for a determination of inconsequentiality allow NHTSA to exempt manufacturers only from the duties found in sections 30118 and 30120, respectively, to notify owners, purchasers, and dealers of a defect or noncompliance and to remedy the defect or noncompliance. Therefore, this decision only applies to the 364 vehicles that BMW no longer controlled at the time it determined that a noncompliance existed. However, the granting of this petition does not relieve distributors and dealers of the prohibitions on the sale, offer for sale, or introduction or delivery for introduction into interstate commerce of the noncompliant vehicles under their control after BMW notified them that the subject noncompliance existed.Start Signature
Issued on: July 9, 2013.
Claude H. Harris,
Director, Office of Vehicle Safety Compliance.
1. BMW of North America, LLC is a U.S. company that manufacturers and imports motor vehicles.Back to Citation
2. BMW AG is a German company that manufactures motor vehicles.Back to Citation
[FR Doc. 2013-17432 Filed 7-19-13; 8:45 am]
BILLING CODE 4910-59-P