Skip to Content

Notice

Notice of Receipt of Petition for Decision That Nonconforming 1992 Jeep Wrangler Multi-Purpose Vehicles Are Eligible for Importation

Document Details

Information about this document as published in the Federal Register.

Enhanced Content

Relevant information about this document from Regulations.gov provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

National Highway Traffic Safety Administration, DOT.

ACTION:

Notice of receipt of petition.

SUMMARY:

This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that nonconforming 1992 Jeep Wrangler Multi-Purpose Passenger Vehicles that were not originally manufactured to comply with all applicable Federal Motor Vehicle Safety Standards (FMVSS), are eligible for importation into the United States because they are substantially similar to vehicles that were originally manufactured for sale in the United States and that were certified Start Printed Page 65757by their manufacturer as complying with the safety standards (1992 Jeep Wrangler Multi-Purpose Passenger Vehicles) and they are capable of being readily altered to conform to the standards.

DATES:

The closing date for comments on the petition is December 2, 2013.

ADDRESSES:

Comments should refer to the docket and notice numbers above and be submitted by any of the following methods:

  • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting comments.
  • Mail: Docket Management Facility: U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
  • Hand Delivery or Courier: West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., between 9 a.m. and 5 p.m. ET, Monday through Friday, except Federal holidays.
  • Fax: 202-493-2251

Instructions: Comments must be written in the English language, and be no greater than 15 pages in length, although there is no limit to the length of necessary attachments to the comments. If comments are submitted in hard copy form, please ensure that two copies are provided. If you wish to receive confirmation that your comments were received, please enclose a stamped, self-addressed postcard with the comments. Note that all comments received will be posted without change to http://www.regulations.gov, including any personal information provided. Please see the Privacy Act heading below.

Privacy Act: Anyone is able to search the electronic form of all comments received into any of our dockets by the name of the individual submitting the comment (or signing the comment, if submitted on behalf of an association, business, labor union, etc.). You may review DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).

How to Read Comments submitted to the Docket: You may read the comments received by Docket Management at the address and times given above. You may also view the documents from the Internet at http://www.regulations.gov. Follow the online instructions for accessing the dockets. The docket ID number and title of this notice are shown at the heading of this document notice. Please note that even after the comment closing date, we will continue to file relevant information in the Docket as it becomes available. Further, some people may submit late comments. Accordingly, we recommend that you periodically search the Docket for new material.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

George Stevens, Office of Vehicle Safety Compliance, NHTSA (202-366-5308).

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Background

Under 49 U.S.C. 30141(a)(1)(A), a motor vehicle that was not originally manufactured to conform to all applicable FMVSS shall be refused admission into the United States unless NHTSA has decided that the motor vehicle is substantially similar to a motor vehicle originally manufactured for importation into and sale in the United States, certified under 49 U.S.C. § 30115, and of the same model year as the model of the motor vehicle to be compared, and is capable of being readily altered to conform to all applicable FMVSS.

Petitions for eligibility decisions may be submitted by either manufacturers or importers who have registered with NHTSA pursuant to 49 CFR part 592. As specified in 49 CFR 593.7, NHTSA publishes notice in the Federal Register of each petition that it receives, and affords interested persons an opportunity to comment on the petition. At the close of the comment period, NHTSA decides, on the basis of the petition and any comments that it has received, whether the vehicle is eligible for importation. The agency then publishes this decision in the Federal Register.

US Specs, of Havre De Grace, MD (Registered Importer R-03-321) has petitioned NHTSA to decide whether nonconforming 1992 Jeep Wrangler Multi-Purpose Passenger Vehicles are eligible for importation into the United States. The vehicles which US Specs believes are substantially similar are 1992 Jeep Wrangler Multi-Purpose Passenger Vehicles that were manufactured for sale in the United States and certified by their manufacturer as conforming to all applicable FMVSS.

The petitioner claims that it compared non-U.S. certified 1992 Jeep Wrangler Multi-Purpose Passenger Vehicles to their U.S.-certified counterparts, and found the vehicles to be substantially similar with respect to compliance with most FMVSS.

US Specs submitted information with its petition intended to demonstrate that non-U.S. certified 1992 Jeep Wrangler Multi-Purpose Passenger Vehicles, as originally manufactured, conform to many FMVSS in the same manner as their U.S. certified counterparts, or are capable of being readily altered to conform to those standards. Specifically, the petitioner claims that non-U.S. certified 1992 Jeep Wrangler Multi-Purpose Passenger Vehicles are identical to their U.S. certified counterparts with respect to compliance with Standard Nos. 102 Transmission Shift Lever Sequence, Starter Interlock, and Transmission Braking Effect, 103 Windshield Defrosting and Defogging Systems, 104 Windshield Wiping and Washing Systems, 105 Hydraulic and Electric Brake Systems, 106 Brake Hoses, 107 Reflecting Surfaces, 113 Hood Latch System, 116 Motor Vehicle Brake Fluids, 124 Accelerator Control Systems, 201 Occupant Protection in Interior Impact, 202 Head Restraints, 204 Steering Control Rearward Displacement, 205 Glazing Materials, 207 Seating Systems, 210 Seat Belt Assembly Anchorages, 211 Wheel Nuts, Wheels Disks, and Hub Caps, 212 Windshield Mounting, 216 Roof Crush Resistance, 219 Windshield Zone Intrusion, 301 Fuel System Integrity, and 302 Flammability of Interior Materials.

The petitioner also contends that the vehicles are capable of being readily altered to meet the following standards, in the manner indicated:

Standard No. 101 Controls and Displays: Modification or replacement of the speedometer to read in miles per hour (MPH) if the vehicle is not already so equipped and replacement of the ECE warning symbol on the brake failure indicator light with the word “BRAKE” to comply with this standard.

Standard No. 108 Lamps, Reflective Devices and Associated Equipment: Replacement of the headlamps, side marker lights, turn signal/park lights, front and rear reflex reflectors, and stop lamps with U.S.-model components if the vehicle is not already so equipped.

Standard No. 111 Rearview Mirrors: Replacement of the passenger side rearview mirror with a U.S.-model component or inscription of the required warning statement on the face of that mirror.

Standard No. 114 Theft Protection and Rollaway Prevention: Installation or reprogramming of the warning buzzer to meet this standard if the vehicle is not already so equipped.

Standard No. 118 Power Operated Window, Partition, and Roof Panel Systems: Installation of the window systems to ensure they meet the requirements of this standard and rewiring there systems to meet the standard if necessary.

Standard No. 119 New Pneumatic Tires for Vehicles Other Than Passenger Start Printed Page 65758Cars: Inspection of vehicle and installation of conforming tires if the vehicle is not already so equipped.

Standard No. 120 Tire Selection for Vehicles Other Than Passenger Vehicles: Installation of an information placard containing manufacturer specifications for seating capacity and loading, and tire specifications if the vehicle is not already so equipped.

Standard No. 206 Door Locks and Door Retention Components: Inspection of door locks and retention components and installation of conforming parts from U.S. Vehicle if the vehicle is not already so equipped.

Standard No. 208 Occupant Crash Protection: Installation of seat belt lamp and audible warning buzzer if the vehicle is not already so equipped.

Standard No. 209 Seat Belt Assemblies: Inspection of seat belts and installation of U.S. model parts if the vehicle is not already so equipped.

The petitioner states that the VIN plate must also be installed on the left front corner of the dashboard to meet the requirements of 49 CFR Part 565.

All comments received before the close of business on the closing date indicated above will be considered, and will be available for examination in the docket at the above addresses both before and after that date. To the extent possible, comments filed after the closing date will also be considered. Notice of final action on the petition will be published in the Federal Register pursuant to the authority indicated below.

Start Authority

Authority: 49 U.S.C. 30141(a)(1)(A), (a)(1)(B), and (b)(1); 49 CFR 593.7; delegation of authority at 49 CFR 1.95 and 501.8.

End Authority Start Signature

Issued on: October 29, 2013.

Claude H. Harris,

Director, Office of Vehicle Safety Compliance.

End Signature End Supplemental Information

[FR Doc. 2013-26101 Filed 10-31-13; 8:45 am]

BILLING CODE 4910-59-P