This PDF is the current document as it appeared on Public Inspection on 03/17/2014 at 08:45 am.
Office of Energy Efficiency and Renewable Energy, Department of Energy.
In this notice, the U.S. Department of Energy (DOE) is forecasting the representative average unit costs of five residential energy sources for the year 2014 pursuant to the Energy Policy and Conservation Act. The five sources are electricity, natural gas, No. 2 heating oil, propane, and kerosene.
The representative average unit costs of energy contained in this notice will become effective April 17, 2014 and will remain in effect until further notice.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Mohammed Khan, U.S. Department of Energy, Office of Energy, Efficiency and Renewable Energy Forrestal Building, Mail Station EE-5B, 1000 Independence Avenue SW., Washington, DC 20585-0121, (202) 586-7892, Rep_Average_Unit_Costs@ee.doe.gov.
Francine Pinto, Esq., U.S. Department of Energy, Office of General Counsel, Forrestal Building, Mail Station GC-72, 1000 Independence Avenue SW., Washington, DC 20585-0103, (202) 586-7432, Francine.Pinto@hq.doe.gov.End Further Info End Preamble Start Supplemental Information
Section 323 of the Energy Policy and Conservation Act (Act) requires that DOE prescribe test procedures for the measurement of the estimated annual operating costs or other measures of energy consumption for certain consumer products specified in the Act. (42 U.S.C. 6293(b)(3)) These test procedures are found in Title 10 of the Code of Federal Regulations (CFR) part 430, subpart B.
Section 323(b)(3) of the Act requires that the estimated annual operating costs of a covered product be calculated from measurements of energy use in a representative average use cycle or period of use and from representative average unit costs of the energy needed to operate such product during such cycle. (42 U.S.C. 6293(b)(3)) The section further requires that DOE provide information to manufacturers regarding the representative average unit costs of energy. (42 U.S.C. 6293(b)(4)) This cost information should be used by manufacturers to meet their obligations under section 323(c) of the Act. Most notably, these costs are used to comply with Federal Trade Commission (FTC) requirements for labeling. Manufacturers are required to use the revised DOE representative average unit costs when the FTC publishes new ranges of comparability for specific covered products, 16 CFR part 305. Interested parties can also find information covering the FTC labeling requirements at http://www.ftc.gov/appliances.
DOE last published representative average unit costs of residential energy in a Federal Register notice entitled, “Energy Conservation Program for Consumer Products: Representative Average Unit Costs of Energy”, dated March 22, 2013, 78 FR 17648. On April 17, 2014, the cost figures published in today's notice will become effective and supersede those cost figures published on March 22, 2013. The cost figures set forth in today's notice will be effective until further notice.
DOE's Energy Information Administration (EIA) has developed the 2014 representative average unit after-tax residential costs found in this notice. These costs for electricity, natural gas, No. 2 heating oil, and propane are based on simulations used to produce the February 2014, EIA Short-Term Energy Outlook (EIA releases the Outlook monthly). The representative average unit after-tax cost for kerosene is derived from its price Start Printed Page 15112relative to that of heating oil, based on the 2009-to 2013 averages of the U.S. refiner price to end users, which include all the major energy-consuming sectors in the U.S. for these fuels. The source for these price data is the January 2014, Monthly Energy Review DOE/EIA-0035(2014/01). The Short-Term Energy Outlook and the Monthly Energy Review are available on the EIA Web site at http://www.eia.doe.gov. Propane prices are econometric modeling projections based on historical Weekly Petroleum Status Report winter prices and Mont Belvieu (Texas) spot and futures prices. For more information on the data sources used in this Notice, contact the National Energy Information Center, Forrestal Building, EI-30, 1000 Independence Avenue SW., Washington, DC 20585, (202) 586-8800, email: email@example.com.
The 2014 representative average unit costs under section 323(b)(4) of the Act are set forth in Table 1, and will become effective April 17, 2014. They will remain in effect until further notice.Start Signature
Issued in Washington, DC, on March 11, 2014.
David T. Danielson,
Assistant Secretary, Energy Efficiency and Renewable Energy.
|Type of energy||Per million Btu 1||In commonly used terms||As required by test procedure|
|Natural Gas||11.28||$1.128/therm4 or $11.56/MCF 5 6||0.00001128/Btu|
|No. 2 Heating Oil||27.04||3.75/gallon 7||0.00002704/Btu|
|Sources: U.S. Energy Information Administration, Short-Term Energy Outlook (February 11, 2014) and Monthly Energy Review (January 30, 2014).|
|Notes: Prices include taxes.|
|1. Btu stands for British thermal units.|
|2. kWh stands for kilowatt hour.|
|3. 1 kWh = 3,412 Btu.|
|4. 1 therm = 100,000 Btu.|
|5. MCF stands for 1,000 cubic feet.|
|6. For the purposes of this table, one cubic foot of natural gas has an energy equivalence of 1,025 Btu.|
|7. For the purposes of this table, one gallon of No. 2 heating oil has an energy equivalence of 138,690 Btu.|
|8. For the purposes of this table, one gallon of liquid propane has an energy equivalence of 91,333 Btu.|
|9. For the purposes of this table, one gallon of kerosene has an energy equivalence of 135,000 Btu.|
[FR Doc. 2014-05949 Filed 3-17-14; 8:45 am]
BILLING CODE 6450-01-P