Skip to Content

Proposed Rule

Airworthiness Directives; Pacific Aerospace Limited Airplanes

Document Details

Information about this document as published in the Federal Register.

Enhanced Content

Relevant information about this document from Regulations.gov provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for Pacific Aerospace Limited Models FU24-954 and FU24A-954 airplanes. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracking of control column at the wiring access hole, which could lead to loss of control. We are issuing this proposed AD to require actions to address the unsafe condition on these products.

DATES:

We must receive comments on this proposed AD by September 19, 2014.

ADDRESSES:

You may send comments by any of the following methods:

  • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
  • Fax: (202) 493-2251.
  • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
  • Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this proposed AD, contact Pacific Aerospace Limited, Airport Road, Hamilton Private Bag 3027 Hamilton 3240, New Zealand; telephone: +64 7 843 6144; fax: +64 7 843 6134; email: pacific@aerospace.co.nz; Internet: http://www.aerospace.co.nz/​. You may review this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0532; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4123; fax: (816) 329-4090; email: karl.schletzbaum@faa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2014-0532; Directorate Identifier 2014-CE-016-AD” at the beginning of your comments. We specifically invite Start Printed Page 45384comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.

We will post all comments we receive, without change, to http://regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.

Discussion

The Civil Aviation Authority (CAA), which is the airworthiness authority for New Zealand, has issued AD DCA/FU24/183, dated May 29, 2014 (referred to after this as “the MCAI”), to correct an unsafe condition for Pacific Aerospace Limited Models FU24-954 and FU24A-954 airplanes and was based on mandatory continuing airworthiness information originated by an aviation authority of another country. The MCAI states:

This AD requires an inspection of the control column for mechanical damage, deformation and cracks per the instructions in Pacific Aerospace Limited (PAL) Mandatory Service Bulletin (MSB) No. PACSB/FU/095 issue 2 dated 28 May 2014. For control columns found with mechanical damage or deformation the AD requires a 50 hour repetitive NDT inspection until replacement. Control column replacement is required at the next maintenance inspection, or within the next 150 hours TIS, whichever is the later.

You may examine the MCAI on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0532.

Relevant Service Information

Pacific Aerospace Limited has issued Mandatory Service Bulletin PACSB/FU/095, Issue 2, dated May 28, 2014. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.

FAA's Determination and Requirements of the Proposed AD

This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with this State of Design Authority, they have notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.

Costs of Compliance

We estimate that this proposed AD will affect 1 product of U.S. registry. We also estimate that it would take about .5 work-hour per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour.

Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $42.50, or $42.50 per product.

In addition, we estimate that any necessary follow-on actions would take about 8 work-hours and require parts costing $1,000, for a cost of $1,680 per product. We have no way of determining the number of products that may need these actions.

According to the manufacturer, some of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all costs in our cost estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Start List of Subjects

List of Subjects in 14 CFR Part 39

  • Air transportation
  • Aircraft
  • Aviation safety
  • Incorporation by reference
  • Safety
End List of Subjects

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

Start Part

PART 39—AIRWORTHINESS DIRECTIVES

End Part Start Amendment Part

1. The authority citation for part 39 continues to read as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]
Start Amendment Part

2. Amend § 39.13 by adding the following new AD:

End Amendment Part

Pacific Aerospace Limited: Docket No. FAA-2014-0532; Directorate Identifier 2014-CE-016-AD.

(a) Comments Due Date

We must receive comments by September 19, 2014.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Pacific Aerospace Limited Models FU24-954 and FU24A-954 airplanes, all serial numbers, certificated in any category.

(d) Subject

Air Transport Association of America (ATA) Code 27: Flight Controls.

(e) Reason

This AD was prompted from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracking of the control column at the wiring access hole. We are issuing this AD to detect and correct cracking of the control column at the wiring access hole which could cause control column failure and subsequent loss of control.

(f) Actions and Compliance

Unless already done, do the following actions in paragraphs (f)(1) through (f)(3) of Start Printed Page 45385this AD, following the accomplishment instructions in Pacific Aerospace Limited Mandatory Service Bulletin PACSB/FU/095, Issue 2, dated May 28, 2014.

(1) Within the next 50 hours time-in-service (TIS) after the effective date of this AD, inspect the control column part number (P/N) 08-45031/32 for cracks.

(2) If any mechanical damage, deformation, or cracks are found, before further flight, replace the control column with an airworthy control column P/N 08-45031/32.

(3) If no mechanical damage, deformation, or cracks are found after the inspection required in paragraph (f)(1) of this AD, at the next scheduled maintenance inspection or within the next 150 hours TIS, whichever occurs later, replace the control column with an airworthy P/N 08-45031/32.

(g) Other FAA AD Provisions

The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4123 ; fax: (816) 329-4090; email: karl.schletzbaum@faa.gov. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(h) Related Information

Refer to MCAI Civil Aviation Authority (CAA) AD DCA/FU24/183, dated May 29, 2014, and Pacific Aerospace Limited Mandatory Service Bulletin PACSB/FU/095, Issue 2, dated May 28, 2014, for related information. You may examine the MCAI on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0532. For service information related to this AD, contact Pacific Aerospace Limited, Airport Road, Hamilton Private Bag 3027 Hamilton 3240, New Zealand; telephone: +64 7 843 6144; fax: +64 7 843 6134; email: pacific@aerospace.co.nz; Internet: http://www.aerospace.co.nz/​. You may review this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.

Start Signature

Issued in Kansas City, Missouri, on July 29, 2014.

James E. Jackson,

Acting Manager, Small Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. 2014-18449 Filed 8-4-14; 8:45 am]

BILLING CODE 4910-13-P