This PDF is the current document as it appeared on Public Inspection on 04/10/2015 at 08:45 am.
U.S. Customs and Border Protection, Department of Homeland Security.
Notice of accreditation and approval of Intertek USA, Inc., as a commercial gauger and laboratory.
Notice is hereby given, pursuant to CBP regulations, that Intertek USA, Inc., has been approved to gauge petroleum and certain petroleum products and accredited to test petroleum and certain petroleum products for customs purposes for the next three years as of September 10, 2014.
Effective Dates: The accreditation and approval of Intertek USA, Inc., as commercial gauger and laboratory became effective on September 10, 2014. The next triennial inspection date will be scheduled for September 2017.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Approved Gauger and Accredited Laboratories Manager, Laboratories and Scientific Services Directorate, U.S. Customs and Border Protection, 1300 Pennsylvania Avenue NW, Suite 1500N, Washington, DC 20229, tel. 202-344-1060.End Further Info End Preamble Start Supplemental Information
Notice is hereby given pursuant to 19 CFR 151.12 and 19 CFR 151.13, that Intertek USA, Inc., 1000 Port Carteret Dr., Building C, Carteret, NJ 07008, has been approved to gauge petroleum and certain petroleum products and accredited to test petroleum and certain petroleum products for customs purposes, in accordance with the provisions of 19 CFR 151.12 and 19 CFR 151.13. Intertek USA, Inc., is approved for the following gauging procedures for petroleum and certain petroleum products from the American Petroleum Institute (API):
Intertek USA, Inc., is accredited for the following laboratory analysis procedures and methods for petroleum and certain petroleum products set forth by the U.S. Customs and Border Protection Laboratory Methods (CBPL) and American Society for Testing and Materials (ASTM):
|27-08||ASTM D-86||Standard test method for distillation of petroleum products at atmospheric pressure.|
|27-48||ASTM D-4052||Standard test method for density and relative density of liquids by digital density meter.|
|27-58||ASTM D-5191||Standard test method for vapor pressure of petroleum products (mini-method).|
|27-50||ASTM D-93||Standard test methods for flash point by Penske-Martens Closed Cup Tester.|
|27-07||ASTM D-4807||Standard Test Method for Sediment in Crude Oil by Membrane Filtration.|
|Start Printed Page 19677|
|27-11||ASTM D-445||Standard test method for kinematic viscosity of transparent and opaque liquids (and calculations of dynamic viscosity).|
|Pending||ASTM D-3606||Standard Test Method for Determination of Benzene and Toluene in Finished Motor and Aviation Gasoline by Gas Chromatography.|
|Pending||ASTM D-5599||Standard Test Method for Determination of Oxygenates in Gasoline by Gas Chromatography and Oxygen Selective Flame Ionization Detection.|
|Pending||ASTM D-5769||Determination of Benzene, Toluene, and Total Aromatics in Finished Gasolines by Gas Chromatography/Mass Spectrometry.|
|27-53||ASTM D-2709||Standard Test Method for Water and Sediment in Middle Distillate Fuels by Centrifuge.|
|27-01||ASTM D-287||Standard test method for API gravity of crude petroleum and petroleum products (hydrometer method).|
|27-06||ASTM D-473||Standard test method for sediment in crude oils and fuel oils by the extraction method.|
|27-13||ASTM D-4294||Standard test method for sulfur in petroleum and petroleum products by energy-dispersive x-ray fluorescence spectrometry.|
|27-04||ASTM D-95||Standard test method for water in petroleum products and bituminous materials by distillation.|
|27-46||ASTM D-5002||Standard test method for density and relative density of crude oils by digital density analyzer.|
Anyone wishing to employ this entity to conduct laboratory analyses and gauger services should request and receive written assurances from the entity that it is accredited or approved by the U.S. Customs and Border Protection to conduct the specific test or gauger service requested. Alternatively, inquiries regarding the specific test or gauger service this entity is accredited or approved to perform may be directed to the U.S. Customs and Border Protection by calling (202) 344-1060. The inquiry may also be sent to CBPGaugersLabs@cbp.dhs.gov. Please reference the Web site listed below for a complete listing of CBP approved gaugers and accredited laboratories http://www.cbp.gov/about/labs-scientific/commercial-gaugers-and-laboratories.Start Signature
Dated: April 2, 2015.
Ira S. Reese,
Executive Director, Laboratories and Scientific Services Directorate.
[FR Doc. 2015-08188 Filed 4-10-15; 8:45 am]
BILLING CODE 9111-14-P