Occupational Safety and Health Administration (OSHA), Labor.
Request for public comments.
OSHA solicits public comments concerning its proposal to extend the OMB approval of the information collection requirements contained in paragraphs (b)(1), (b)(6)(i), (b)(6)(ii), (c)(15)(ii), (e)(1)(i), (ii), and (iii) and (f)(2) of the Standard on Rigging Equipment for Material Handling. These paragraphs require affixing identification tags or markings on rigging equipment, developing and maintaining inspection records, and retaining proof-testing certificates.
Comments must be submitted (postmarked, sent, or received) by June 23, 2017.
Electronically: You may submit comments and attachments electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal. Follow the instructions online for submitting comments.
Facsimile: If your comments, including attachments, are not longer than 10 pages, you may fax them to the OSHA Docket Office at (202) 693-1648.
Mail, hand delivery, express mail, messenger, or courier service: When using this method, you must submit a copy of your comments and attachments to the OSHA Docket Office, OSHA Docket No. OSHA-2010-0038, Occupational Safety and Health Administration, U.S. Department of Labor, Room N-3653, 200 Constitution Avenue NW., Washington, DC 20210. Deliveries (hand, express mail, messenger, and courier service) are accepted during the Department of Labor's and Docket Office's normal business hours, 10:00 a.m. to 3:00 p.m., e.t.
Instructions: All submissions must include the Agency name and OSHA docket number (OSHA-2010-0038) for the Information Collection Request (ICR). All comments, including any personal information you provide, are placed in the public docket without change, and may be made available online at http://www.regulations.gov. For further information on submitting comments, see the “Public Participation” heading in the section of this notice titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the docket, go to http://www.regulations.gov or the OSHA Docket Office at the address above. All documents in the docket (including this Federal Register notice) are listed in the http://www.regulations.gov index; however, some information (e.g., copyrighted material) is not publicly available to read or download from the Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. You may also contact Theda Kenney at the address below to obtain a copy of the ICR.
Start Further Info
FOR FURTHER INFORMATION CONTACT:
Theda Kenney or Todd Owen, Directorate of Standards and Guidance, OSHA, U.S. Department of Labor, Room N-3609, 200 Constitution Avenue NW., Washington, DC 20210; telephone (202) 693-2222.
End Further Info
Start Supplemental Information
The Department of Labor, as part of its continuing effort to reduce paperwork and respondent (i.e., employer) burden, conducts a preclearance consultation program to provide the public with an opportunity to comment on proposed and continuing information collection requirements in accord with the Paperwork Reduction Act of 1995 (PRA) (44 U.S.C. 3506(c)(2)(A)). This program ensures that information is in the desired format, reporting burden (time and costs) is minimal, collection instruments are clearly understood, and OSHA's estimate of the information collection burden is accurate. The Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C. 651 et seq.) authorizes information collection by employers as necessary or appropriate for enforcement of the OSH Act, or for developing information regarding the causes and prevention of occupational injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also requires OSHA to obtain such information with minimum burden upon employers, especially those operating small businesses, and to reduce to the maximum extent feasible unnecessary duplication of efforts in obtaining information (29 U.S.C. 657).
Paragraph (b)(1) of the Standard 29 CFR 1926.251 requires that alloy steel chains have permanently affixed, durable identification tags stating size, grade, rated capacity and sling manufacturer. Paragraph (b)(6)(i) requires the employer to make a thorough periodic inspection of alloy steel chain slings in use on a regular basis, but at least once a year. Paragraph (b)(6)(ii) requires the employer to make and maintain a record of the most recent month in which each alloy steel chain was inspected and make the record available for examination.
Paragraph (c)(15)(ii) requires that all welded end attachments of wire rope slings be proof tested by the manufacturer at twice their rated capacity prior to initial use, and that the employer retain a certificate of the proof test and make it available for examination.
Paragraphs (e)(1)(i), (ii), and (iii) require that synthetic web slings be marked or coded to show the manufacturer's name or trademark, the rated capacity for the type of hitch and the type of synthetic webbing material.
Paragraph (f)(2) requires that all hooks for which no applicable manufacturer's recommendations are available be tested twice before they are put into use. The employer shall maintain a record of the dates and results of the tests.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
- Whether the proposed information collection requirements are necessary for the proper performance of the Agency's functions, including whether the information is useful;
- The accuracy of OSHA's estimate of the burden (time and costs) of the information collection requirements, including the validity of the methodology and assumptions used;
- The quality, utility, and clarity of the information collected; and
- Ways to minimize the burden on employers who must-comply for example, by using automated or other technological information collection and transmission techniques.Start Printed Page 18935
III. Proposed Actions
OSHA is requesting that OMB extend its approval of the information collection requirements contained in the Standard on Rigging Equipment for Material Handling (29 CFR 1926.251). The Agency is requesting an increase in the burden hours from 51,815 burden hours to 52,428 hours. This increase is due to the additional marking requirements for wire rope slings.
Type of Review: Extension of a currently approved collection.
Title: Rigging Equipment for Material Handling (29 CFR 1926.251).
OMB Control Number: 1218-0233.
Affected Public: Business or other for-profits.
Number of Respondents: 1,220,910.
Total Responses: 278,343.
Frequency of Responses: On occasion.
Average Time per Response: Average of 3 minutes (.05 hour) for an employer to maintain and disclose a certificate to 30 minutes (.50 hour) for an employer to acquire information and make a tag for a sling.
Estimated Total Burden Hours: 52,428.
Estimated Cost (Operation and Maintenance): $0.
IV. Public Participation—Submission of Comments on This Notice and Internet Access to Comments and Submissions
You may submit comments in response to this document as follows: (1) Electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal; (2) by facsimile (fax); or (3) by hard copy. All comments, attachments, and other material must identify the Agency name and the OSHA docket number for the ICR (OSHA Docket No. 2010-0038). You may supplement electronic submissions by uploading document files electronically. If you wish to mail additional materials in reference to an electronic or facsimile submission, you must submit them to the OSHA Docket Office (see the section of this notice titled ADDRESSES). The additional materials must clearly identify your electronic comments by your name, date, and the docket number so the Agency can attach them to your comments.
Because of security procedures, the use of regular mail may cause a significant delay in the receipt of comments. For information about security procedures concerning the delivery of materials by hand, express delivery, messenger, or courier service, please contact the OSHA Docket Office at (202) 693-2350, (TTY (877) 889-5627).
Comments and submissions are posted without change at http://www.regulations.gov. Therefore, OSHA cautions commenters about submitting personal information, such as social security numbers and dates of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted material) is not publicly available to read or download through this Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. Information on using the http://www.regulations.gov Web site to submit comments and access the docket is available at the Web site's “User Tips” link. Contact the OSHA Docket Office for information about materials not available through the Web site, and for assistance in using the Internet to locate docket submissions.
V. Authority and Signature
Dorothy Dougherty, Deputy Assistant Secretary of Labor for Occupational Safety and Health, directed the preparation of this notice. The authority for this notice is the Paperwork Reduction Act of 1995 (44 U.S.C. 3506 et seq.) and Secretary of Labor's Order No. 1-2012 (77 FR 3912).
End Supplemental Information
Signed at Washington, DC, on April 13, 2017.
Deputy Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. 2017-08226 Filed 4-21-17; 8:45 am]
BILLING CODE 4510-26-P