Skip to Content


Softwood Lumber from Canada; Scheduling of the Final Phase of Countervailing Duty and Antidumping Duty Investigations

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


United States International Trade Commission.




The Commission hereby gives notice of the scheduling of the final phase of antidumping and countervailing duty investigation Nos. 701-TA-566 and 731-TA-1342 (Final) pursuant to the Tariff Act of 1930 (“the Act”) to determine whether an industry in the United States is materially injured or threatened with material injury, or the establishment of an industry in the United States is materially retarded, by reason of imports of softwood lumber from Canada, provided for in subheadings 4407.10.01, 4409.10.05, 4409.10.10, 4409.10.20, 4409.10.90, 4418.90.10. Subject merchandise may also be classified in subheadings 4415.20.40, 4415.20.80, 4418.99.90, 4421.91.70, and 4421.91.97 of the Harmonized Tariff Schedule of the United States, preliminarily determined by the Department of Commerce to be subsidized and sold at less-than-fair-value.


Effective June 30, 2017.

Start Further Info


Fred Ruggles (202-205-3187,, Office of Investigations, U.S. International Trade Commission, 500 E Street SW., Washington, DC 20436. Hearing-impaired persons can obtain information on this matter by contacting the Commission's TDD terminal on 202-205-1810. Persons with mobility impairments who will need special assistance in gaining access to the Commission should contact the Office of the Secretary at 202-205-2000. General information concerning the Commission may also be obtained by accessing its internet server ( The public record for these investigations may be viewed on the Commission's electronic docket (EDIS) at

End Further Info End Preamble Start Supplemental Information


Scope.—For purposes of these investigations, the Department of Commerce has defined the subject merchandise as softwood lumber, siding, flooring and certain other coniferous wood (softwood lumber products).[1] The scope includes:

Coniferous wood, sawn, or chipped lengthwise, sliced or peeled, whether or not planed, whether or not sanded, or whether or not finger-jointed, of an actual thickness exceeding six millimeters.

Coniferous wood siding, flooring, and other coniferous wood (other than moldings and dowel rods), including strips and friezes for parquet flooring, that is continuously shaped (including, but not limited to, tongued, grooved, rebated, chamfered, V-jointed, beaded, molded, rounded) along any of its edges, ends, or faces, whether or not planed, whether or not sanded, or whether or not end-jointed.

Coniferous drilled and notched lumber and angle cut lumber.

Coniferous lumber stacked on edge and fastened together with nails, whether or not with plywood sheathing.

Components or parts of semi-finished or unassembled finished products made from subject merchandise that would otherwise meet the definition of the scope above.

Softwood lumber product imports are generally entered under Chapter 44 of the Harmonized Tariff Schedule of the United States (HTSUS). This chapter of the HTSUS covers “Wood and articles of wood.” Softwood lumber products that are subject to this investigation are currently classifiable under the following ten-digit HTSUS subheadings in Chapter 44: 4407.10.01.01; 4407.10.01.02; 4407.10.01.15; 4407.10.01.16; 4407.10.01.17; 4407.10.01.18; 4407.10.01.19; 4407.10.01.20; 4407.10.01.42; 4407.10.01.43; 4407.10.01.44; 4407.10.01.45; 4407.10.01.46; 4407.10.01.47; 4407.10.01.48; 4407.10.01.49; 4407.10.01.52; 4407.10.01.53; 4407.10.01.54; 4407.10.01.55; 4407.10.01.56; 4407.10.01.57; 4407.10.01.58; 4407.10.01.59; 4407.10.01.64; 4407.10.01.65; 4407.10.01.66; 4407.10.01.67; 4407.10.01.68; 4407.10.01.69; 4407.10.01.74; 4407.10.01.75; 4407.10.01.76; 4407.10.01.77; 4407.10.01.82; 4407.10.01.83; 4407.10.01.92; 4407.10.01.93; 4409.10.05.00; 4409.10.10.20; 4409.10.10.40; 4409.10.10.60; 4409.10.10.80; 4409.10.20.00; 4409.10.90.20; 4409.10.90.40; and 4418.99.10.00.

Subject merchandise as described above might be identified on entry documentation as stringers, square cut box-spring-frame components, fence pickets, truss components, pallet components, flooring, and door and window frame parts. Items so identified might be entered under the following ten-digit HTSUS subheadings in Chapter 44: 4415.20.40.00; 4415.20.80.00; 4418.99.90.05; 4418.99.90.20; 4418.99.90.40; 4418.99.90.95; 4421.91.70.40; and 4421.91.97.80.

Although these HTSUS subheadings are provided for convenience and customs purposes, the written description of the scope of these investigations is dispositive.

The scope of the order excludes the following items: U.S.-origin lumber shipped to Canada for processing and imported into the United States is excluded from the scope of the investigations if the processing occurring in Canada is limited to one or more of the following: (1) Kiln drying; (2) planing to create smooth-to-size board; or (3) sanding. Box-spring frame kits are excluded if they contain the following wooden pieces—two side rails, two end (or top) rails and varying numbers of slats. The side rails and the end rails must be radius-cut at both ends. The kits must be individually packaged and must contain the exact number of wooden components needed to make a particular box spring frame, with no further processing required. None of the components exceeds 1″ in actual thickness or 83″ in length. Radius-cut box-spring-frame components, not exceeding 1″ in actual thickness or 83″ in length, ready for assembly without further processing are excluded. The radius cuts must be present on both ends of the boards and must be substantially cut so as to completely round one corner.

Background.—The final phase of these investigations is being scheduled pursuant to sections 705(b) and 731(b) of the Tariff Act of 1930 (19 U.S.C. 1671d(b) and 1673d(b)), as a result of affirmative preliminary determinations by the Department of Commerce that certain benefits which constitute subsidies within the meaning of section 703 of the Act (19 U.S.C. 1671b) are being provided to manufacturers, producers, or exporters in Canada of Start Printed Page 32377softwood lumber, and that such products are being sold in the United States at less than fair value within the meaning of section 733 of the Act (19 U.S.C. 1673b). The investigations were requested in petitions filed on November 25, 2016, by the Committee Overseeing Action for Lumber International Trade Investigations or Negotiations (the “Coalition”).[2]

For further information concerning the conduct of this phase of the investigations, hearing procedures, and rules of general application, consult the Commission's Rules of Practice and Procedure, part 201, subparts A and B (19 CFR part 201), and part 207, subparts A and C (19 CFR part 207).

Participation in the investigations and public service list.—Persons, including industrial users of the subject merchandise and, if the merchandise is sold at the retail level, representative consumer organizations, wishing to participate in the final phase of these investigations as parties must file an entry of appearance with the Secretary to the Commission, as provided in section 201.11 of the Commission's rules, no later than 21 days prior to the hearing date specified in this notice. A party that filed a notice of appearance during the preliminary phase of the investigations need not file an additional notice of appearance during this final phase. The Secretary will maintain a public service list containing the names and addresses of all persons, or their representatives, who are parties to the investigations.

Limited disclosure of business proprietary information (BPI) under an administrative protective order (APO) and BPI service list.—Pursuant to section 207.7(a) of the Commission's rules, the Secretary will make BPI gathered in the final phase of these investigations available to authorized applicants under the APO issued in the investigations, provided that the application is made no later than 21 days prior to the hearing date specified in this notice. Authorized applicants must represent interested parties, as defined by 19 U.S.C. 1677(9), who are parties to the investigations. A party granted access to BPI in the preliminary phase of the investigations need not reapply for such access. A separate service list will be maintained by the Secretary for those parties authorized to receive BPI under the APO.

Staff report.—The prehearing staff report in the final phase of these investigations will be placed in the nonpublic record on August 28, 2017, and a public version will be issued thereafter, pursuant to section 207.22 of the Commission's rules.

Hearing.—The Commission will hold a hearing in connection with the final phase of these investigations beginning at 9:30 a.m. on Tuesday, September 12, 2017, at the U.S. International Trade Commission Building. Requests to appear at the hearing should be filed in writing with the Secretary to the Commission on or before September 6, 2017. A nonparty who has testimony that may aid the Commission's deliberations may request permission to present a short statement at the hearing. All parties and nonparties desiring to appear at the hearing and make oral presentations should participate in a prehearing conference to be held on September 8, 2017, at the U.S. International Trade Commission Building, if deemed necessary. Oral testimony and written materials to be submitted at the public hearing are governed by sections 201.6(b)(2), 201.13(f), and 207.24 of the Commission's rules. Parties must submit any request to present a portion of their hearing testimony in camera no later than 7 business days prior to the date of the hearing.

Written submissions.—Each party who is an interested party shall submit a prehearing brief to the Commission. Prehearing briefs must conform with the provisions of section 207.23 of the Commission's rules; the deadline for filing is September 5, 2017. Parties may also file written testimony in connection with their presentation at the hearing, as provided in section 207.24 of the Commission's rules, and posthearing briefs, which must conform with the provisions of section 207.25 of the Commission's rules. The deadline for filing posthearing briefs is September 19, 2017. In addition, any person who has not entered an appearance as a party to the investigations may submit a written statement of information pertinent to the subject of the investigations, including statements of support or opposition to the petition, on or before September 19, 2017. On October 6, 2017, the Commission will make available to parties all information on which they have not had an opportunity to comment. Parties may submit final comments on this information on or before October 10, 2017, but such final comments must not contain new factual information and must otherwise comply with section 207.30 of the Commission's rules. All written submissions must conform with the provisions of section 201.8 of the Commission's rules; any submissions that contain BPI must also conform with the requirements of sections 201.6, 207.3, and 207.7 of the Commission's rules. The Commission's Handbook on E-Filing, available on the Commission's Web site at, elaborates upon the Commission's rules with respect to electronic filing.

Additional written submissions to the Commission, including requests pursuant to section 201.12 of the Commission's rules, shall not be accepted unless good cause is shown for accepting such submissions, or unless the submission is pursuant to a specific request by a Commissioner or Commission staff.

In accordance with sections 201.16(c) and 207.3 of the Commission's rules, each document filed by a party to the investigations must be served on all other parties to the investigations (as identified by either the public or BPI service list), and a certificate of service must be timely filed. The Secretary will not accept a document for filing without a certificate of service.

Start Authority

Authority: These investigations are being conducted under authority of title VII of the Tariff Act of 1930; this notice is published pursuant to section 207.21 of the Commission's rules.

End Authority Start Signature

By order of the Commission.

Issued: July 10, 2017.

Lisa R. Barton,

Secretary to the Commission.

End Signature End Supplemental Information


1.  Certain Softwood Lumber Products From Canada: Preliminary Affirmative Determination of Sales at Less Than Fair Value, 82 FR 29833, June 30, 2017

Back to Citation

2.  The Coalition is an ad hoc association whose members are: U.S. Lumber Coalition, Inc., Collum's Lumber Products, L.L.C., Hankins, Inc., Potlach Corp., Rex Lumber Company, Seneca Sawmill Company, Sierra Pacific Industries, Stimson Lumber Company, Swanson Group, Weyerhaeuser Company, Carpenters Industrial Council, Giustina Land and Timber Company, Sullivan Forestry Consultants, Inc. The Coalition is “an association, a majority of whose members is composed of interested parties” described in Section 771(9)(C) of the Act, 19 U.S.C. 1677(9)(C).

Back to Citation

[FR Doc. 2017-14718 Filed 7-12-17; 8:45 am]