Federal Aviation Administration (FAA), DOT.
This action removes Class E airspace areas designated as an extension to a Class D surface area at Springfield-Beckley Municipal Airport, Springfield, OH. This action is required as a result of an airspace review, which inadvertently overlooked the removal of the associated Class E airspace extensions when the Class D airspace was removed.
Effective 0901 UTC, November 8, 2018. The Director of the Federal Register approves this incorporation by reference action under Title 1 Code of Federal Regulations part 51, subject to the annual revision of FAA Order 7400.11 and publication of conforming amendments.
FAA Order 7400.11B, Airspace Designations and Reporting Points, and subsequent amendments can be viewed online at http://www.faa.gov/air_traffic/publications/. For further information, you can contact the Airspace Policy Group, Federal Aviation Administration, 800 Independence Avenue SW, Washington, DC 20591; telephone: (202) 267-8783. The Order is also available for inspection at the National Archives and Records Administration (NARA). For information on the availability of FAA Order 7400.11B at NARA, call (202) 741-6030, or go to https://www.archives.gov/federal-register/cfr/ibr-locations.html.
FAA Order 7400.11, Airspace Designations and Reporting Points, is published yearly and effective on September 15.
Start Further Info
FOR FURTHER INFORMATION CONTACT:
Rebecca Shelby, Federal Aviation Administration, Operations Support Group, Central Service Center, 10101 Hillwood Parkway, Fort Worth, TX 76177; telephone (817) 222-5857.
End Further Info
Start Supplemental Information
Authority for This Rulemaking
The FAA's authority to issue rules regarding aviation safety is found in Title 49 of the United States Code. Start Printed Page 45555Subtitle I, Section 106 describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the agency's authority. This rulemaking is promulgated under the authority described in Subtitle VII, Part A, Subpart I, Section 40103. Under that section, the FAA is charged with prescribing regulations to assign the use of airspace necessary to ensure the safety of aircraft and the efficient use of airspace. This regulation is within the scope of that authority as it supports the removal of the Class E airspace designated as an extension to Class D surface area no longer needed at Springfield-Beckley Municipal Airport, Springfield, OH.
The FAA published a notice of proposed rulemaking in the Federal Register (83 FR 19986; May 7, 2018) for Docket No. FAA-2017-1051 to remove Class E airspace designated as an extension to a Class D surface area at Springfield-Beckley Municipal Airport, Springfield, OH. Interested parties were invited to participate in this rulemaking effort by submitting written comments on the proposal to the FAA. No comments were received.
Class E airspace designations are published in paragraph 6004 of FAA Order 7400.11B, dated August 3, 2017, and effective September 15, 2017, which is incorporated by reference in 14 CFR 71.1. The Class E airspace designations listed in this document will be published subsequently in the Order.
Availability and Summary of Documents for Incorporation by Reference
This document amends FAA Order 7400.11B, Airspace Designations and Reporting Points, dated August 3, 2017, and effective September 15, 2017. FAA Order 7400.11B is publicly available as listed in the ADDRESSES section of this document. FAA Order 7400.11B lists Class A, B, C, D, and E airspace areas, air traffic service routes, and reporting points.
This amendment to title 14 Code of Federal Regulations (14 CFR) part 71 removes the Class E airspace designated as an extension to Class D airspace at Springfield-Beckley Municipal Airport, Springfield, OH.
The air traffic control tower has closed, and Class E extension airspace removed, as the airport no longer qualifies for controlled airspace.
Regulatory Notices and Analyses
The FAA has determined that this regulation only involves an established body of technical regulations for which frequent and routine amendments are necessary to keep them operationally current, is non-controversial and unlikely to result in adverse or negative comments. It, therefore: (1) Is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034; February 26, 1979); and (3) does not warrant preparation of a regulatory evaluation as the anticipated impact is so minimal. Since this is a routine matter that only affects air traffic procedures and air navigation, it is certified that this rule, when promulgated, does not have a significant economic impact on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
The FAA has determined that this action qualifies for categorical exclusion under the National Environmental Policy Act in accordance with FAA Order 1050.1F, “Environmental Impacts: Policies and Procedures,” paragraph 5-6.5.a. This airspace action is not expected to cause any potentially significant environmental impacts, and no extraordinary circumstances exist that warrant preparation of an environmental assessment.
Start List of Subjects
End List of Subjects
- Incorporation by reference
- Navigation (air)
Adoption of the Amendment
In consideration of the foregoing, the Federal Aviation Administration amends 14 CFR part 71 as follows:
PART 71—DESIGNATION OF CLASS A, B, C, D, AND E AIRSPACE AREAS; AIR TRAFFIC SERVICE ROUTES; AND REPORTING POINTS
Start Amendment Part
1. The authority citation for part 71 continues to read as follows: End Amendment Part
Start Amendment Part
2. The incorporation by reference in 14 CFR 71.1 of FAA Order 7400.11B, Airspace Designations and Reporting Points, dated August 3, 2017, and effective September 15, 2017, is amended as follows:End Amendment Part
Paragraph 6004 Class E Airspace Areas Designated as an Extension to a Class D or Class E Surface Area.
* * * * *
AGL OH E4 Springfield, OH [Removed]
End Supplemental Information
Issued in Fort Worth, Texas, on August 30, 2018.
Acting Manager, Operations Support Group, ATO Central Service Center.
[FR Doc. 2018-19475 Filed 9-7-18; 8:45 am]
BILLING CODE 4910-13-P